Suzuki GT380 - Points Timing

Рет қаралды 7,299

2 жыл бұрын

I have fitted points back on the Suzuki GT380 after having a problem with the Boyer Bransden electronic ignition, initially just to rule out any other issues.
The bike actually ran much better than it ever did so I have decided to keep the points on it!
In this video I go through the points timing procedure... or how I do it anyway!

Пікірлер: 22

@arthurturner3080 29 күн бұрын

Thanks for this, very helpful

@LeonardoCostaUSA 4 ай бұрын

Awesome video, sir!!

@martynstansfield6203 6 ай бұрын

Lovely and responsive. I’ve had same problems with my 750 after rebuild. The triple pick up plate failed. But keep having problems with my right cylinder. Lovely video tho

@grahams6690 2 жыл бұрын

Hi enjoyed your video, I am just queries to know, do these 2 strokes run on e5-e10 petrol. cheers

@InTheShedUK 2 жыл бұрын

Hi, I usually fill up with E5, I have put in E10 when I have not been able to get E5 and it runs fine (later diluting with E5). It's the ethanol which is a problem, not very good for crankcase oil seals and other rubber components! Also not all E5 is equal... the bike club I belong to tests the local fuel, for example in May Esso Super 97 RON had NO ethanol but Shell V-Power 99 RON was at least 4% ethanol.

@richarddegen6184 Жыл бұрын

@@InTheShedUK I use 90 octane no ethanol fuel here in Texas in the R5

@andrewoffer7369 7 ай бұрын

Had one as a teenager, never ran ok as in my ignorance i thought the contact breakers we’re timed for when they closed, wondered why I had to turn the base plate so much to get it to run 😳

@InTheShedUK 7 ай бұрын

ahhh the innocence of youth!

@simonollman3723 7 ай бұрын

I was told never turn the nut on the points side as you risk breaking the plastic gear behind in the case?

@InTheShedUK 7 ай бұрын

Possible, if you have the plugs in and you try to turn the engine over. I did only make a small final adjustment with the spanner.

@ProChicken 11 ай бұрын

Hello i have problems with spark, my gt gets power to the coils but no spark, are the coils bad or?

@InTheShedUK 11 ай бұрын

Coils can be checked with a multimeter for open circuit, you should see some resistance if good, about 3 ohms from memory, but they can still breakdown under load. Change condenser if in doubt, check your points gap, then timing.

@ProChicken 11 ай бұрын

@@InTheShedUK Thank you very much, I will try

@richardcarey169 7 ай бұрын

Ah the dark arts

@richarddegen6184 Жыл бұрын

I use a dial indicator and test light on my Yamaha R5

@parikibandasudeshna897 2 ай бұрын

Hi, Iam not getting a buzzer beep, how much ever I advance or retard. I grounded the multimeter to frame and lead to white wire. Am I doing something wrong, or do I need new points ?

@InTheShedUK 2 ай бұрын

Have you set your points gap first? If you have check the buzzer is working by touching the test leads together, check ground is good, check continuity of the white wire end to end, check points are actually closing either visually or see if you can slip your thinnest feeler gauge in. Hope you get it sorted.

@sicks6six 8 ай бұрын

You need CDI ignition system fitted. 🎉

@InTheShedUK 8 ай бұрын

A CDI ignition for the GT380 would require a new stator as CDI requires exciter coils, the ones I have seen don't have any lighting coils (not much space left due to 3 exciter coils required) and are really for racing, hence no lighting coils. Also the kit costs about £450!

@InTheShedUK 8 ай бұрын