Thanks for watching and yes it runs better with the foams versus those stock rubber.

Appreciate that! I used a 32p 23t brass Pinion. Thanks for watching!

U sure it's not .6 mod

I do recommend because there are some upgrades for it. There are metal gears for it now. There is a link below for the metal spur gear for your reference and I would suggest a HR metal Pinion if possible. The metal gears are 48p I believe and with a 23t pinion paired with the metal spur gear below may give you the speed you are looking for (not sure though). The motor shaft size I used is a 3.175 shaft (but you can make what you want fit). Thanks for watching & be safe! www.ebay.com/itm/134016315433?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=CSnd4oHVSoy&sssrc=2349624&ssuid=4r0e61ber22&var=&widget_ver=artemis&media=COPY

@@PJsElectricRCAdventures ok mate no problem atal thankyou very much and I assume you mean HR Asin hardened metal and does the p matter I'm assuming mate will have look out for some just don't want it to be wrong 🙏💚👊

@@sTuPiDiScOoL_ 48p is the teeth size of the gear some reference it as mod/pitch 0.6 gear. You are correct about the hardened Metal Pinion.

@@PJsElectricRCAdventures thankyou my brother that is most helpful I am just watching through your videos mate to get a good idea also the diffs look like quite easy to access and I'm assuming they are open like a wltoys for example and metal so need greasing every so often could be wrong thanks boss 🙏💚👊

@@sTuPiDiScOoL_ the diffs are easy to access and they are open. The metal diffs are housed inside a white plastic diff housing. So greasing will be most important if ran hard. I don't run mine much but when I do I try to improve my drifting skills 🤣

Yes it came with wheel nuts