Honestly I didn’t measure. It fit perfect they way I put it in. I guess I lucked into it’s figment.

Glad I can help. Thanks for watching and feel free to ask if you have any questions. And good luck with your build.

Thank you. And thanks for watching 👍

It did not. I watched their online video on KZfaq and then installed it.

@@crusadergarage298 cool yeah I just thought they have provided some dimensions and so forth. Lol. Did you install the main hoop 90 degrees/straight up? I heard them talking about a 3degree lean back and wasn’t sure how to do the main hoop. Thanks for your response and videos!

Yeah I did set it at about a 3 degree lean back.

No trouble at all.

TeamZ

Not at all.

Not sure if it would work with heater box/ blower motor. I would guess not. Also I don’t believe a dash bar is required for an 8.50 cert if the firewall is not modified more than 1 square foot.

@@crusadergarage298 appreciate the info brotha. I'll have to look into that. Love your work. I can't tig so I'm looking at the steel version so I can mig it. Happen to know the weight differences between the steel and moly?

Same cage in mild steel will probably weight at least 50lbs more.

I lowered my cage so I could weld the tops. Before I raised it back up I installed the headliner. Buy you still could install it after the cage is done. Would just be more of a Pain. I have not installed my rear interior panels yet because I am going to replace the 1/4 windows. Once I do that I will install the rest. 👍

@@crusadergarage298 just feed everything from the hatch is what I was thinking. I'm sure it'll will be a wrestle. Thanks bud.

👍 thanks for watching

Chromoly.

Im looking at the same cage for my 90 foxbody hatchback. What add ons did you do?

Just the mini tub/ triangulation bars

That back bar for me was a tight fit. It stayed in place enough between the plate enough for me to keep fitting the rear bars in till I found the right spot for me to weld it in.

@@crusadergarage298 Thanks for the reply, I was wondering if it would stay in place. I was going to try that today. It’s 4am here in Cali and I can’t wait to get back outside on it. Did you drop the whole cage down or just the front?

I dropped the entire cage down. I marked the rear bars with a sharpie around the plates and tacked them in, so all I had to do was raise them back up to the marks to weld in

@@crusadergarage298 Awesome, good job. Was it a bitch to get back into position? I work alone and thinking of using a couple floor jacks to get it back into position. How did you do it?

Used a ratchet strap across the roof and through the a pillar bars that run horizontally on the roof line and just ratchet it up and placed back on my marks. Hope that makes sense

Not at all. Went in very easy

Yes it will.

Most of it was pretty easy. A couple spots were hard because where they are. It’s hard to get to them with the torch. But all in all was not that bad.