Very good,,its great that we have people like him cause if ya were stuck on something ya could see how he goes about fixing it,,,ya very good fairplay to em,,🇮🇪

Works great for a firebird thanks ! very helpful

Great video for the ones that’s never messed with body panels luckily or unlucky pending the job😜😜😜 for myself I’ve been wrestling with 1st-4th gens all my life

Hell yeah great video, you guys are rocking it.. I'm subscribing

Great video. I could have used this a couple of years back when I was fighting with mine :)

Thank you so much for the info.

Awesome info man I appreciate it thank you sir

Thanks. Fixed up my alignment issues

very helpful, thank you for sharing

Thanks for the info. Subscribed.

Thanks Joe!

Thanks a ton I will be doing this soon since your shops not in Chicago

That’s why I have over 30 hours of welding and grinding gaps in my car. I’ve never seen one that didn’t fit like shit from the factory, shims and adjusting only get you so far.

I'm glad I found your channel. I'm having very similar issues on a 64 Chevelle that I'm working on. On the underside of the hood (the edge) of this Chevelle seems to be touching the inside of the fender causing it to stay raised. Would you have any suggestions. I wish I could insert a picture. I'd really like to contact you but I don't want to be a bother. Any help is greatly appreciated!

You are my fucking hero. Watched your video and now my hood fits perfectly.

Good job

Having same problem with my 81 ta will try this out tomorrow

Good stuff

I have loosen the three bolts to where they are about out. And it won't budge. It tight up against my door so it is chipping the paint like you are talking but the fender will not pull forwards any other tips. Thanks

Do you guys have any advice on fisher T Top weather stripping? Can you make one seal at all??

where do the body shims go on 2nd gen f bodies only thing i know is that there is 4 total two on each side but where

My hood sticks up 1/4 inch at the front and more on the front edges. Any recommendations? 1978 trans am shaker hood.

Can you adjust the front fenders out so they fit better to the rubber bumper?

You guys think sagging doors would cause a big problem too? I’m putting in new door pins and bushing soon

How much do you think something like this would cost to fix more or less if you take it in? Just the front of my car needs to be realigned.

What do I need to do I have a 1974 Camaro and my hood is lined up well in each corner however it’s high towards the back and isn’t flush with the fenders. The hood hinges are adjusted all the way down. What do I do?

Hey man, there's some weird looking dude that shows up in the reflections every now and then. Can he be edited out? lol