Ten speed transmission leaking air from valve on the top and why. Eaton Fuller Fro16210c shift top🥹

No video

Ten speed transmission leaking air from valve on the top and why. Eaton Fuller Fro16210c shift top🥹

Рет қаралды 12,886

ETR Truck Center | Engine & DriveTrain Specialist

Күн бұрын

This is the second video on the same subject this time with bubbles. This video is going to show you that even the new modulator on top dosent help if the plate is trashed. This is an extremely common problem with these transmissions. Water and rust damage is the culprit here if you want to avoid this issue make absolutely sure to keep your air system dry and drained of any water. Thank you guys for watching and hope this video helps mabe better than the first video I did. Don’t forget to like and subscribe!! I’ll show you how to check the fabled modulator in the next video.
Have a good one.

Пікірлер: 22

@CashNYC 8 ай бұрын

Drain your air tanks every morning this happened to me

@caleblee4856 Жыл бұрын

Good luck on your hunt! Love you videos.

@GJ20028 11 ай бұрын

good content.....but I want to know what is the part number of the plate with the components...thanks

@andrewlipman2387 Жыл бұрын

Hiya just watched your video it was fab.we use to have that transmission here in the UK. I believe if memory serves me right it was a12 speed. I remember the key way in the top cover breaking.and also at the rear of the transmission there was a plate with 2 bolts in front of it there was a pin to use to break and turn .driver would call say he stuck in no man land with his gears.would go out undo the 2 bolts remove the cover stick a screwdriver in the shift it hadT stamped in it turn it to the top fit a new cover plate on his way he would go.

@etrtruckcenterenginedrivet8918 Жыл бұрын

Glad you enjoyed the video . Would definitely like to see what you guys are running as far as manual transmissions there in the UK. This is a 10 speed Eaton Fuller top plate by the way but yes there are two different styles of this top. There is a key top and a lug style top and yes the key style top is known for breaking and leaving you stranded.

@andrewlipman2387 Жыл бұрын

Hiya thanks for replying back. Well over here we're using these automatic transmissions I've not had anything to do with them really .There in Daf trucks volvo and scanias .There good when there going right but I no owner operator's that run them. Very very expensive to repair .ie if the computer on top of the gearbox goes thatcan cost up to £3000 pound. Lol I'm 57 old school I like the Eatons back in the day we had 9 and 13 speeds . Then Eaton brought out a gearbox called the Twinsplitter that was a fabulous box

@b.k.sautomarinedieselrepai5143 Жыл бұрын

Have you made the video how to test the top plate?

@mariothanasi2017 11 ай бұрын

Hi guys. I had a leak on top of the air module valve( valve itself was cracked and been leaking). With the old valve i had no leaks underneath the valve. I changed with the new one. In the morning when i move the splitter to higher gear i hear air noise not the click, but still changes the gears without problem. After 10 minutes works good, no air leaks sound and does the click up and down normally. What can cause this. Maming me crazy. I opened 3 times the valve..

@harley13purenrg 3 ай бұрын

I have a 13 speed. My truck is leaking air at the red splitter button, but only in high gear. I drain my tanks regularly. And have rarely encountered water draining from the tanks. It is an eaton fuller trans, not sure of model. But it is in a 22 lonestar, wiki 320k miles. It just started yesterday, and the leak is faint. But aside from it being annoying, I'm worried it's going to lead to further problems down the line.

@etrtruckcenterenginedrivet8918 3 ай бұрын

It could be an issue with the splitter cylinder possibly rust on the inside causing air to bypass around the oring in the piston/cylinder wall.

@apacheindian5267 9 ай бұрын

Can that leaking top plate cause air pressure in the secondary tank not to build properly?

@williamsimmons867 10 ай бұрын

How about a 15 speed bypassing air .want go high to low

@shawnrice7179 Жыл бұрын

should we be putting wd 40 penetrateing oil in our air tanks?

@gifinoc3356 Жыл бұрын

How much does it cost to fix that? Thanks

@marcelinojuarez5604 Жыл бұрын

Modulator=600 Top plate= 2800 Labor=1200 Plus miscellaneous, tax and tip 😊

@etrtruckcenterenginedrivet8918 Жыл бұрын

😳

@madrid27100 6 ай бұрын

Damn , mine can continue leaking air I guess 😂, the top plate cost more than the whole rebuild transmission

@michaelhatcher873 2 ай бұрын

@@madrid27100 right

@SecretSex Жыл бұрын

A very good and useful video !!

@etrtruckcenterenginedrivet8918 Жыл бұрын

Glad you think so!

@luisxalteno5860 Жыл бұрын

Hey bud I have a Eaton super 10 that got stuck in gear and I’m trying to get it back to neutral. I took of the tower and I’m playing with the bars. What do you think cause it to get stuck in gear? Should I be worry or could it be a simple fix

@etrtruckcenterenginedrivet8918 Жыл бұрын

You may have a broken reverse gear snapring. It needs to come out to be repaired. It’s easy to break a mainshaft when this issue happens.