NOT SEEN THIS DONE BEFORE!...Delta Tub Spout Diverter Repair

Рет қаралды 33,798

2 жыл бұрын

NOT SEEN THIS DONE BEFORE!...Delta Tub Spout Diverter Repair. This Delta tub spout diverter was not a bad diverter we just needed to fix broken tub spout. Learning how to fix shower diverter may save money on replacement of tub spout. Subscribe here :kzfaq.info...
Silicone grease link: amzn.to/3wzoEhB
Clear Siliconized caulk: amzn.to/374HVNF
Teflon tape link: amzn.to/2Jo9hik
14-1 painter's tool link: amzn.to/2xEkc4Q
Contractors Sponge 3 pack link: amzn.to/33X9R05
(Amazon Affiliate Links)
Did Our Video Help you? Please Consider Helping Out the Channel
www.paypal.com/donate/?cmd=_s...
Check us out on Facebook: / ufix247
We love helping people and hope that we are doing that!
Guitar Clip by Audionautix is licensed under a Creative Commons Attribution license
(creativecommons.org/licenses/...)
Artist: audionautix.com/

Пікірлер: 51

@Farm_fab 2 жыл бұрын

Brian, for your viewers, when using teflon tape, it's important not to put on too much as this can squeeze outward the plastic mating surface, potentially cracking it and causing more leaks. Usually 2 or 3 wraps should be adequate.

@ThatFixItGuy 2 жыл бұрын

I totally mentioned that and ended up editing it out because it was too long. Great minds think alike. I will pin this!

@morganbauer 2 ай бұрын

I had exactly this situation. O ring dropped down. Took it apart and put it back together. Amazing.

@jacobsilvens8153 2 жыл бұрын

Hope all is well after your procedure. Wishing you a speedy recovery.

@ThatFixItGuy 2 жыл бұрын

Thank you. All is well so far. On the mend for sure.

@edlily4185 Жыл бұрын

Thanx! You saved me $50+ of replacement! I had exactly the same issue!

@ThatFixItGuy Жыл бұрын

Wow right on. No a big fan of the design. Glad you got it hooked up. Please subscribe, share your experience and help us grow.

@kentforman8836 2 жыл бұрын

Nice job on finding the missing piece. Nice Bob Ross impersonation cleaning the caulk.

@ThatFixItGuy 2 жыл бұрын

Lol!

@herbmueller5259 4 ай бұрын

An amazing video! The Delta spouts can be very difficult to understand, let alone repair. Exact replacement spout alone can be near $100! This is the first video that I’ve seen that gets inside the works. You do great communication!

@joshcooper130 Жыл бұрын

The round tip of the pull tab comes off. If you hold the shaft the tab is connected to with needle nose or small pliers to keep it from rotating, and rotate the tip, it should come right off. Then just remove the gray cap and o-ring and the entire assembly slides right out. Much faster and no risk of damaging the plastic internals. Excellent job and excellent video! 👌

@ThatFixItGuy Жыл бұрын

Thank you for that insight. I really appreciate it.

@ericm6594 Жыл бұрын

Make a video

@stevesproul3744 2 жыл бұрын

Great video brother. Another thing everyone should know how to fix. I hope you’re feeling better and healing fast buddy.

@ThatFixItGuy 2 жыл бұрын

Thank you Steve. This worked out better than I could have thought. I’m feeling better every day. Thanks for the thoughts and prayers.

@susanseymour2997 2 жыл бұрын

Thanks for the tips Brian! Always helpful!

@ThatFixItGuy 2 жыл бұрын

Your quite welcome. I hope we can help again.

@luciw9928 Жыл бұрын

Thank you very much for this video!! The same thing happened with my son’s spout!! 🥰❤️

@Evangelistaadventures Жыл бұрын

Great video bud!! Great problem solving!!

@robfarley3436 Жыл бұрын

This was a big help for me today. Thanks

@johnbaggett7789 2 жыл бұрын

I Larned something to day thanks for what ya do .

@ThatFixItGuy 2 жыл бұрын

Your welcome. So glad you are enjoying the content. Thank you for watching. I really enjoying the learning as well.

@Evangelistaadventures Жыл бұрын

Nice find in the drain!

@clovisgauthier3602 Жыл бұрын

Great job. Kohler says their spouts don't have serviceable parts so I bought a new one on eBay because my spout was discontinued.

@geraldalfano5581 2 жыл бұрын

I always seal around the copper tube coming through the tile with plumbers' putty to prevent water from getting behind the wall.

@ThatFixItGuy 2 жыл бұрын

That is a great call. Thanks for sharing that tip.

@theMekanik 2 жыл бұрын

They need to build a house where all the plumbing & wiring is ran on the outside of the walls. Make it happen & make the power DC. 😎

@ThatFixItGuy 2 жыл бұрын

I have plumbed a couple buildings like that in the desert.

@deannacalef3513 2 жыл бұрын

Wow! How fortunate for you that gizmo dropped where you could find it. Nice content for sure.

@ThatFixItGuy 2 жыл бұрын

Totally agree. When I found that it was like striking gold. Thank you for checking it out

@pingliu2147 2 жыл бұрын

There is a small hole underneath of the base of this spout. You seemed not use silicon to seal it. You just applied both sides underneath the spout. I followed your video. Very helpful. I called Delta, they said it is up to me to seal it or not. Seem not a big deal. Do I need to seal that hole or leave it open? Thank you for your answer.

@ThatFixItGuy Жыл бұрын

I always leave that hole open. It is a good way to pop the plate up after caulked in place if you ever have to work on something.

@TheCodesterr Жыл бұрын

Man this was entertaining. I’ve been trying to find a matte black tub spout that will fit the delta adapter like this, and this is the only one. The reviews online are kinda bad, do you think the water flow is okay? Any drips from the spout when the diverted is up?

@brittblanton8342 2 жыл бұрын

Great video Brian, any idea what cut the grooves in the tub by the drain? I hope you are feeling better and have a speedy recovery 👍🇺🇸

@ThatFixItGuy 2 жыл бұрын

Thank you Britt. I don’t know what caused that in the tub. It seems weird that I would come that way and they would be ok with it.

@cheapbeersucks Жыл бұрын

How big was the O ring? I need to replace mine.

@threatmurda508 Жыл бұрын

Better luck then me, my crappy discontinued delta spout that's similar to this has 0 lee way to put the lil plastic gate to hook up t the pin 🤦🏽‍♂️🤦🏽‍♂️ previous homeowners did a hack job to on top of it with a crappy Delta valve

@nickvasile5354 Жыл бұрын

How do you remove that copper fitting. I was trying to replace the diverter spout but can't remove it.

@ranger178 2 жыл бұрын

i buy silicone grease in 55-gallon drums because i use it on everything car boat electric plumbing all gets silicone lol

@ThatFixItGuy 2 жыл бұрын

lol! That’s a lotta lube! Thank you Greg.

@theMekanik 2 жыл бұрын

1st! 🤘🏻😎🤘🏻

@ThatFixItGuy 2 жыл бұрын

Hope you have been well 😎

@theMekanik 2 жыл бұрын

Now bak to Deuterium & Helium-3 Reaktors

@ThatFixItGuy 2 жыл бұрын

I love that you take time out of your different educational material to check out our lowly channel from time to time. Thank you

@shmootube5000 10 ай бұрын

i have a similar spout except round with that stupid extra plastic piece inside, except that extra piece snapped. ive found no replacements for it anywhere, i hate that they’re made with this extra nonsense that only complicates things.

@blueticecho5690 2 жыл бұрын

You remind me of Jerry Mathers that Beaver guy from the 50's... gee Wally the stool won't flush.

@ThatFixItGuy 2 жыл бұрын

😂 I loved that show. At least I’m not Eddie Haskell! 😂

@blueticecho5690 2 жыл бұрын

@@ThatFixItGuy That's super good for you cause he's dead... Ha..

@mythbuster7631 8 ай бұрын

no offense but you making it more difficult that it needs to be. The trick is that the shaft can be separated from the head, it's just screwed on. Hold the shaft with the pliers, unscrew the head and it all becomes easy