The Ultimate DIY 40gal Parts Washer?

Рет қаралды 6,796

8 ай бұрын

Here's the list of parts used for my mods:
Ball valves/petcocks: amzn.to/3QVWlCG
T-fitting: amzn.to/3sFCvnt
Y-fittings: amzn.to/40WlQIL
NPT Ball Valve: amzn.to/3sEogPL
Barbed Ball Valve: amzn.to/47uLuXM
Pump: amzn.to/3uvqTUF
Drain barbed fitting: amzn.to/3uurVA3
Barbed outlet for pump: amzn.to/3MSzKFV
Barbed fitting for T: amzn.to/3uwFeQE
Buckets/Shovels: amzn.to/3Gde8At
Loc-Line nozzles, NPT adapter: amzn.to/40VMuSi
Loc-Line pliers: amzn.to/47H0rW4
Loc-Line 5' coil: amzn.to/47xUA68
Loc-Line double female adapter: amzn.to/3uvnpBq
My Amazon Associate links help me to pay for the labor of creating these videos. Your support is greatly appreciated!

Пікірлер: 6

@dontblameme6328 Ай бұрын

Great video! SuperClean is super powerful but tends to be corrosive on certain alloys.

@yablabo 8 ай бұрын

Nice work around for your solvent reservoir. The pump in the bucket is like the old enco coolant reservoirs for milling machines. Looks like a nice DIY project. Well done!

@doomsdaydiesel 8 ай бұрын

I would look that up, but enco is dead 😭😭 Thanks! Happy Thanksgiving

@tonnyplaysgames220dailygam5 4 ай бұрын

Do you have an updated video? Great ideas. I just wanna see the finished setup.

@B30_Drew 6 ай бұрын

Very well put together video, much more discriptive compared to others about DIY part washers. Have you determined what solution is ideal overall yet? Have you considered adding a heater element to break down more grease and dirt?

@doomsdaydiesel 6 ай бұрын

I use a Hotsy if I need heat, because even the most stubborn crud won't come off till you get over 200°. I hate the PSC. I will change to Super Clean + Distilled water as soon as this stuff is done. I can't stand the smell or how much it sticks to everything, including me. The filtration of just 1 bucket is working amazingly well so far. I've cleaned 3 intake manifolds with no problems. With the stock setup, just 1 manifold would ruin all your fluid.