how much are they?

@@adelaidewinetours 1800

What projects do you usually work on?

@@allenchan6549 kitchen cabinets and countertops and cars this thing is amazing!!

Tell me about it. I put two coats front and back on 300 cabinet doors using Ben Moore advance in 6 hours I don't know how I lived without this thing for so many years. And I did all that with one gallon of paint that's the fastest five grand I ever made

@@ihave35cents95 Did you spray the BM Advance un-thinned? I have the Fuji Q5. It doesn't come close to being able to spray Advance or Cabinet Coat un-thinned without serious orange peel and dry spray. Looking at getting a TriTech T5.

@@ILruffian I cut the advance with one quart of floetrol and then I thinned each cup about 5 percent. With number 4 tip. Comes out like glass. If that doesn't work use a number 5 airhead. I did notice the other day I didn't need to thin as much when I used a gravity-fed gun. Ben Moore does say you'll have no problem spraying it with a 4 or 5 stage turbine. Just make sure you get three mils on there so Advanced can do what it was designed to do and that is level out.

Which filter do you remove?

@@leodesforges161 the metal mesh filter that is inside the spray gun paint can. Just pull it off and comes out easy

I was asking about which filter in your airless you remove. The gun filter or the large prefilter.

@@leodesforges161 I thought I was clear my apologies; the gun filter

@@leodesforges161 Do that only with continuous use so no buildup occurs a d wash thoroughly afterwards!

Hi there you can definitely run any turbine gun brand you want off the unit, the PSI on the high and low setting ill check

Sherwin Williams emerald

I use the PPG breakthrough, go to cabinet paint. Dries uniform, fast and higher viscosity for less thinning or none at all depending on what you are trying to do.

Hi I don't think it will centurion needs air assist airless, airless with a fine finish tip or a conventional (non hvlp) spray gun

We like the Graco gx 19 with tritech fine finish tips or a tritech t4 hopper unit

Hi Chris it's a bit subjective but here would be my thoughts the titan 115 capspray is the only 6 stage turbines on the market this provides alot of paint breakup power it also has a low pressure switch for stains however fuji q series have better heat control and a bit more gun options. For heavy thick paints capspray 115 for long spray sessions or quieter fuji may be the route

Technically you could though I would recommend the Apollo precision 5 with the automotive spray gun kit that has air caps and nozzles setup for car painting

This is the Apollo automotive setup

pittsburghsprayequip.com/products/apollo-bare-p5prole-120v-5-stage-turbo-paint-system-w-b7600-spray-gun-stainless-black

@@PittsburghSprayEquipmentCo Ok. Thx.

De que parte de Mexico Eres carnal? Yo aqui estoy de Este lado del charco ocupas una de esas???

Don’t use it then

It’s not very noisy. Put ear plugs in.