There is a mold that will grow inside the fuel tank and if still installed behind the font bumper on the right side frame rail, there is a small fuel water separator with ceramic disk in it and mold will also form inside it. It can be serviced and will avoid problems down the road.

Yet somehow Peg would drive it back to oilberta with no issues. That man's got super powers I swear

A friend had a boat that would do very close to what you are seeing. It would run great at first and then run out of power a little later. What I finally found was the fuel tank vent in the cap was stuck closed. After the truck about quits open fuel cap and see if it hisses. Good Luck! Great videos. I hope you pay the narrator a lot he is fun to listen to.

Babe wake up, toocheaptosmoke uploaded

The block inside you were talking about is called the sleeve and it rides on the plunger. Even if the plunger was stuck in the up position the sleeve would still be on the bottom because it's in a shutdown position. All the way down leaves the spill Port open. All the way up it completely blocks to spell port and you have full throttle.

hahahahah the turn signal led light setup is the best thing I've seen in a while!

Definitely put a fuel pressure gauge on there. And try running it out of a jug to bypass the tank and see if there's a change!

My 86 CUCV M1008 likes to test my patience and bank account as well. Luckily it’s mainly just a regular Chevy K30, aside from the oddball 12/24V electrical and whatnot.

Put a quart of oil in your fuel each time fill up, that help keep the fuel pump and injection pump lubricanted, newer diesel fuel is dry.

Nice change for the oil filter.

👌👌

I was going to guess a venting problem. As it uses up what air is available in tank it begins to starve. But that might be more lawn mower technology than anything.

Thanks man, great video!

Great video. But I can’t wait for the sled videos now that winter is here

Is the deuce half full? Or half empty?! You! The FAVORITE KZfaq viewer can decide.

I would love to see the look on the face of the newbie AAA driver who shows up for the service call.

We have been working on our 1973 model at our scout camp and cannot get it to start, we changed the fuel filters, and bled the lines, it just drips out while cranking, I thought it’s supposed to squirt out? The injection pump is the next item to go after. We’ll disconnect that damn buzzer for sure! The external fuel pump is a great idea. Let me your thoughts. Thanks

Where can i buy the 24 volt fuel pump you are using in the duece im looking for something like it to use as a small fuel transfer pump dont need to move alot at a time but cant get fuel cans over the fill line in my small fuel tank i need to fill i use the duece i have for hauling scrap metal and waste oil and the small pumping system for collecting oil uses a small diesel powered pump i installed under the trailer needing a small pump to fill its tank and hate carring tons of exstra parts loose in the tool box for filling it going to use the pump to add a larger tank on the trailer to pump over to the small tank as needed

any suggestion on a place to buy the little clip that holds the button on thank you

nice work! do a update vid on the groil stuff :D

Has it got any biocide in the tank to kill bugs? That makes everything size up usually snaps rotary fuel pumps in half

How hard do you have to pull up on the cap to get it off after aligning the red tooth? I have mine aligned but the cap won't pull off.

Wait what isn’t that thing from diesel creek 😂

I’m sure the pump isn’t high enough pressure for the injectors is the filter pre pump or aft pump , the way that filter was implored it’s starving for fuel .

Just saying, modern diesel will eat up the rubber in the lines and jam it in liquid form into the high pressure pump. I’ve changed a gang of them in old diesels.