In this video I replace the fuel filter on my 3.0L TDi Touareg. Simple job to do your self. Follow along as I get this done. And don't forget to like the video Thanks
Пікірлер: 15
@pauliussimkus84014 ай бұрын
Very informative/self explanatory! Thank you.
@garysgarage21184 ай бұрын
Thanks for your comments.
@treborhammer965220 күн бұрын
very good video ,,, is the only way to prime the fuel canister is with a scan tool ??
@garysgarage211820 күн бұрын
@@treborhammer9652 no. You can fill it manually before closing it up. Or cycle the key (ignition) about 8 times. It’s just easier with the scan tool.
@BradWhite-ry9uj3 ай бұрын
Gary what is if we don't have the tool to prime the filter after installing. Is there a way to pre-prime the filter manually?
@garysgarage21183 ай бұрын
Yes. When you turn on the ignition without your foot on the brake, the fuel pump will run for approximately 2 sec. Do that 8 times and you should be good to go. If there is a little air left it will just be a longer crank time.
@BradWhite-ry9uj2 ай бұрын
@@garysgarage2118 Thank you.
@skywest14324 ай бұрын
🙌🏻👍🏻
@treborhammer965220 күн бұрын
also I'm curious to the name and model of scan tool
@garysgarage211820 күн бұрын
@@treborhammer9652 It is a Think Diag 2.
@treedeblue7 ай бұрын
Not everyone has a fancy scan tool when doing this job btw
@garysgarage21187 ай бұрын
Just fill the filter housing with fresh fuel before closing. It works well.
@edwardplant87427 ай бұрын
Just cycle the ignition a few times to initiate the lift pump a few times then.
@treedeblue7 ай бұрын
Thanks will do both suggestions. What are ur thoughts on the fuel pump failure throwing metal into the system? Sounds like a ticking time bomb for us
@garysgarage21187 ай бұрын
Thanks for adding your comment. Good solution for some without a bidirectional scan too.