I finally have time to address this hydraulic issue with my International 674 tractor
Пікірлер: 12
@MagaRicknАй бұрын
My father in law bought a new 674D in 1973 to celebrate me marrying his last daughter! I still got the daughter and the tractor! ;) Nice diesel tractor, and fairly easy to work on also. I had a front end loader installed years ago, and it's like having 4 hired hands for this old man! 😉
@circlepfarm3776Ай бұрын
The International 674 has been a good tractor for me. It's just about the perfect size and HP. I don't know what I would do without it. Congratulations on keeping the tractor and the daughter.
@MagaRicknАй бұрын
@@circlepfarm3776 Thanks! I am looking for videos on repairing the lines to the steering under the steering wheel. Mine are leaking big time!
@circlepfarm3776Ай бұрын
@@MagaRickn I have not tried fixing the leaks from the steering. Mine leaks some from the actual steering pump below the steering wheel but not bad enough to try tearing the pump apart. Hopefully you can just replace the lines. If I do decide to tear into mine, I will definitely make a video of it.
@colmanlong1032 Жыл бұрын
Lovely tractor and video, it has very good hydraulics
@circlepfarm3776 Жыл бұрын
Thank you. I don’t know what I would do without this tractor. It’s big enough to do what I need, yet nimble enough for small lots.
@colmanlong1032 Жыл бұрын
@@circlepfarm3776 bought one a couple of yrs ago,can't get over how far ahead ih were in the 70s,beautiful tractor to drive.
@donvoll25806 ай бұрын
@@colmanlong1032 Good day from Ontario. Yes they were good tractors. Thanks
@donvoll25806 ай бұрын
Good day from Ontario. Interesting video. Those magnets are they round. I have some come off flashing light Yes thety pinch Is that a dunham lehr loader? single cyl in front Thanks
@circlepfarm37766 ай бұрын
The magnets are disc shaped. They are about 5mm thick and 10mm diameter. Yes, it is a Dunham Lehr loader with the single cylinder for bucket tilt. Thanks for watching.
@iantye20864 ай бұрын
Gaday from Queensland, Australia. I’ve got problems with the 3 pt linkage lifting and lowering while slashing. It will now only lift & lower via the draft control lever. My steering and bucket go fine. Could this be the issue or am I doing something else wrong?
@circlepfarm37764 ай бұрын
Have you checked the friction washer under the lift control lever? You may just need to tighten it up a bit.