How to Replace Rack & Pinion Assembly 2003-2007 Honda Accord

Рет қаралды 46,433

9 ай бұрын

Shop for New Auto Parts at 1AAuto.com 1aau.to/c/242/ap/rack-and-pini...
This video shows you how to install a new rack & pinion assembly from TRQ on your 2003-2007 Honda Accord. The rack and pinion assembly transforms the turning motion of your steering wheel to the push and pull motions that turn the front wheels of your vehicle, as well as adding the power assistance. If the steering rack on your vehicle is leaking, or damaged in some way, you might need to replace it entirely.
This repair was done on a 2006 Honda Accord EX 2.4L Sedan 4-Door FWD Automatic and the process should be similar on the following vehicles:
2003 Honda Accord
2004 Honda Accord
2005 Honda Accord
2006 Honda Accord
2007 Honda Accord
Tools you will need:
• 17mm Wrench 1aau.to/o2x/1AXAA00010
• 19mm Wrench 1aau.to/o2x/1AXAA00010
• 10mm Socket 1aau.to/obk4/1AXAA00017
• Trim Tool Set 1aau.to/oain/1AXXX00006
• Socket Extensions 1aau.to/obGt/1AXAA00015
• Torque Wrench 1aau.to/oaN6/1AXAA00044
• Gloves 1aau.to/oaqj/1AXSS00048
• Painter's Tape
• Power Steering Fluid
• Safety Glasses
• Floor Jack 1aau.to/oade/1AXAA00068
• Funnel
• Jack Stands 1aau.to/oZQ/1AXAA00065
• Wheel Chocks
Subscribe: / @trq
Check out our playlist:
Honda Accord 2003-2007 7th Gen: • Honda Accord 2003-2007...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

Пікірлер: 35

@redrider5628 5 ай бұрын

Thanks. So far process worked great. Great video. I’m sure it was difficult to capture all the angles. Some of those areas was very hard to get to.

@hudongng 9 ай бұрын

Thank you for your v/clip, it’s useful for everyone. ❤

@matjoe272 8 ай бұрын

Thank you very much for showing how its done. Thumbs up.

@wiseguymoney Ай бұрын

Thank you thank you thank you, this step by step was awesome and made my life easier, and saved me about 800 dollars thx again

@SaidAttalah 7 ай бұрын

Amazing! Thank you for sharing.

@user-te9bo5yn7d 9 ай бұрын

Thanks a lot very useful clip

@user-qx4jy3on8j 4 ай бұрын

Thank you so much for your help

@CheletoVlog 8 ай бұрын

Replacing my 2007 and the pressure lines are both 17. Also didn't need a 24 mm for removing the steering linkage. Was a 19 mm. But my new one came with those and control arms.

@christopherbrown5338 6 ай бұрын

Excellent video! Is there a way to verify if either the rack or pump is faulty?

@boywonder8175 8 ай бұрын

Good info

@UserRjt 5 күн бұрын

This the same for 3.5l v6 accord 2011?

@paulwodarz4663 5 ай бұрын

Thank You 😊

@sweetdevil6221 7 ай бұрын

Thanks ❤

@algentles5361 2 ай бұрын

HI, does the same method work for the HR drive Honda Accord?

@VuNguyen-nk7mx 5 ай бұрын

Thanks!

@itzjay_1678 8 ай бұрын

What about that plastic yellow piece on the input shaft is it important to reinstall that

@eddroid4585 7 ай бұрын

Nice man👋👋👋👋👋👋🇧🇷

@1chip4you Ай бұрын

Is this close to the same as the newer 09-10/14 accords/tsx’s with the electric power steering just without the fluid?

@creepyscope7824 7 ай бұрын

How bout 8th gen is it the same procedure?

@jayrocksxxasap1273 Ай бұрын

Love the work you do brother. I have a question for you... So i have a 2003 honda pilot.. Only axel that matched up was a 2002 axel... The trans side was just a little bit shorter.. But the axel that was with vins did not match.

@jayrocksxxasap1273 Ай бұрын

My question is.. Would that make a whole lot of difference?

@sricharte89 5 ай бұрын

its all good and all, but helps if you have a lift as is makes it easier also a place to do it in, can be done on your pavement but more difficult to get underneath and do all that

@OGS_623 Ай бұрын

Does snyone knows the exact name of the pliers used to turn the rack before installing. Last tool I nedd before seslping mines. Id greatly appreciate the help!

@TRQ 9 ай бұрын

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

@unebonnevie 7 ай бұрын

The car model here is probably a V6 not a 4-cylinder, as V6 is more complicated. Some key notes: 1) Center the steering wheel/the front wheels and tie down the steering wheel before doing the work. This is to prevent the airbag clock spring from the being damaged if the steering gets turned during the process. (At least, that's my understanding.) 2) Centering the new rack & pinion at 18:47. 3) When putting in the new rack & pinion (at 22:45), make sure the two lines (the high pressure line and the return line) are loosely covered with the plastic cover, then loosely attach the two lines. Then loosely tighten all the nuts and bolts onto the new rack & pinion. Then go back and tighten the two lines' bolts. And finally tighten all the bolts. 4) At 31:10 how to put back the outer tie rods. Looks like in the video he put in the outer tie rod's tiny boot at an angle rather plush onto the flat side of the knuckle. Wouldn't that be a problem?

@lami7403 6 ай бұрын

thanks for your time bro that's was helpful

@Lifesituations8000 5 ай бұрын

Is that the v6?

@zekizeks 3 ай бұрын

PLEASE HELP!! WHICH OIL GOES ?? I HAVE ACCORD CL7 2003

@jasonblowers4540 4 ай бұрын

9:30 I have everything apart and still can't get the rack out.

@2626whwh 2 күн бұрын

Would this same procedure work on my 06 TL?

@TRQ 2 күн бұрын

+@2626whwh The installation should be very similar.

@balkee42 7 ай бұрын

Same pretty much as an 07 acura tl?

@TRQ 7 ай бұрын

+@balkee42 This procedure might be different for your application. We do not currently have a how-to video for this particular year, make and model. Thank you for asking! 1aau.to/m/Shop-TRQ