Updating the low speed needle tuning again guys hope it can help . Thank you and don't forget to subscribe . #fun #tune #rc #nitro #relax #perfect #speed
Пікірлер: 11
@louiesfixit21 күн бұрын
Thanks for this video this was soooooo helpful
@user-bh2ri1ct3t6 ай бұрын
simple and informative
@dozyrcworld38476 ай бұрын
Glad it was helpful!
@therookiercguy6 ай бұрын
Awesome
@ironhead3204 ай бұрын
Sweet
@ice-pol8961 Жыл бұрын
Does that mean. Moving the LSNeedle clockwise/forwards into the hole is restricting fuel flow therefore allowing more air, resulting in higher revs, bogging and a far hotter engine?
@Baker_1911 Жыл бұрын
Yes that’s correct
@Bang_n_slang13 күн бұрын
Not sure if this is the same issue I’m having. Same engine .25 on Kyosho. It’s basically new but The idle seems to rev up and down then will shut off if I’m not giving it gas. Any suggestions?
@ironhead3202 ай бұрын
I don't know i tried all kinds of ways here after running for 10-15 minutes runs good the when i go the pull full throttle it just boggs down and sounds like it.going to shut off.Its a 3.3 hsn 3-1/2 out low 1-1/2 out.
@strictlybanks86123 ай бұрын
It’s weird my 3.3 shuts off right at 5 seconds with the fuel pinch test but I can’t ever get a good low end tune I don’t get it
@ironhead3203 ай бұрын
Question just got my revo 3.3 out now when running it has a gurgling.Right now my high side about 2 turns out my low side I get 3 seconds and it dies out on the pinch test