Where’d you buy the nozzle and nozzle return spring from? I’m not having the greatest luck googling
@ema16716 ай бұрын
The nozzle came from Evike, the spring was from hadron in UK.
@clockwork69668 күн бұрын
i have 2 of these and both have had the same issue. its an expected issue, going into full auto on semi at times. i replaced the hammer (just the hammer) on one and it fixed it until it inevitably happened again. i expected it to break but it happened quite quickly, same with the other. im considering getting a steel replacement hammer set and i think any g18 or aap set will do but i was wondering if you have had such issues after using yours for quite some time, and if you made upgrades to the hammer set after this video was posted?
@ema16716 күн бұрын
I haven't touched the 18C hammer assembly in a while but iirc that issue is because the hammer sear is not catch/holding the hammer. You gotta check that the trigger bar is not getting stuck, that the hammer sear is making full travel and that the hammer is being held by the hammer sear.
@jovannyfeliciano66043 ай бұрын
Did you had to sand down the red nozzle like you did on the original one?
@ema16713 ай бұрын
No
@dannycesmistruk54555 ай бұрын
have you had a problem with the nozzle carrier(slider)? mine looks really worn and it stick some times.
@ema16715 ай бұрын
No, I haven't had an issue like that.
@jovannyfeliciano66044 ай бұрын
Where can I get that piece that catches the nozzle and pulls it out of the hop up?