I have found when I do a path combine it resizes the width and height a tiny bit like .010. You can see it change in the width and height boxes when doing a combine. So I just do a group. Thanks for the vid. With the price of steel today, cutting out parts twice is $$. I now use the Pen tool attachment. Yes it adds a few minutes more time but paper and tape is cheaper than steel. Well at least right now it is. I have a couple vids of the pen tool set up on my channel. I subed to your channel. Thanks for the vid.

What a strange table. I love it! Did you build it yourself? I love how you can side-load it super easy with the way it's built. Never seen a table that's meant to be up against a wall like that before. Really innovative.

A more accurate way to do the center-to-center measurement (assuming the holes are the same size) is to measure the diameter of one hole, then zero your caliper. Then take the outside to outside measurements of the holes. Zeroing the caliper removes one hole diameter from the equation...which is what you need to do for a c-t-c measurementand is much more accurate than eyeballing it.