Support the channel making a donation at www.paypal.me/... buycoffee.to/f...
Пікірлер: 47
@thegauldys9092 жыл бұрын
This advice is spot on used to be a sparkie myself you would be amazed how many faults show as parts when dirty wiring/connections are the issue Just sorted my 1.7di combo with this issue dirty pin on ecu plug! Runs a treat😀
@paulhayestiling22142 жыл бұрын
Thanks very much for your advice, I have a 2011 Opel combo 1.3cdti with the Z13DTJ engine and I have the exact symptoms you described with the throttle, I replaced the pedal, but it doesn't seem to have worked, so am going to try the cleaning route. Cheers from Ireland
@AndreasKahl6 жыл бұрын
Great video, thanks for the information and tips. I cleaned all of the connectors and relays as suggested, it solved my poor throttle response problem and cleared the inspection light on the dash.
@stevejones42755 жыл бұрын
Also works on Vauxhall Agila! Unclip the plugs to the ECU (fastened to battery-side of engine. Clean plugs and sockets with solvent. Put them back. Reset the codes with a cheap code reader. Result: car is good, no P1122. Thanks.. ..
@margaretflude91106 жыл бұрын
Hope the fly by wire sensors in planes are more robust than the ones in my Zafira
@khakaanali45906 ай бұрын
Absolutely brilliant video.. 👏 👌
@IonutJaR4 жыл бұрын
Thanks solved my problem!!
@paulkomn9462 жыл бұрын
the workshop's mechanicians put dislike. LOL
@nakoncuswiata96577 жыл бұрын
to help others - i had 1120 & 1122 on my astra h 2004 . after inspection it turns out the reason was blocked turbo with all possible stain from slow town driving - been cleared out , and so far its good as shoud . before was getting in limp mode once engine was wormed up . hopefully not happen again
@fixanddrive7 жыл бұрын
Hard to believe that was the reason. Keep an eye on the error codes, they might return.
@nakoncuswiata96577 жыл бұрын
ecu been checked and looks dry. acceleration pedal been changed by previous owner and obviously it didn't help. if limp mode will back on again, I will look at connection between pedal and ecu so far over 100miles and no issues
@cristianiancubc2 жыл бұрын
Thanks for info.
@garethslinn79552 жыл бұрын
This will work with error code p112-08 (no throttle signal to ecu) definitely try before messing with any ecu’s
@attilacs.5703 жыл бұрын
112008: pedal sensor clean -UEC clean- cabel move or change- ECU connectors clean, renewal or change
@cooliebaii44937 жыл бұрын
the vehicle is equipped with fail safe mechanism it does not mean that particular sensor is bad for this code toyota has it where they state it is because of the coolant valve position sensor is bad the idle will go up and down then the fail safe mechanism kicks in and shuts down the throttle motor where the cable is only opening it a little to get yu to a shop also yu can mess up yu spark plugs then yu misfire
@aslandelyon13136 жыл бұрын
Great information, but I had to mute that horrible sound. A sexy British lady voice over would have been more effective. 😅
@MrBarrytommy5 жыл бұрын
Great thanks for this info
@jeep62767 жыл бұрын
impec.... ça marche... merci beaucoup. ... ;-)
@braveridecry8 жыл бұрын
Thanks for this
@georgegratsias10428 жыл бұрын
Thanks very useful!
@ltomovski7 жыл бұрын
Hi .. I get the ESP light ON and the pedal only throttles when on gear .. when it is on neutral .. it does not throttles .. can it be the same issue ..
@fixanddrive7 жыл бұрын
that's really bizarre , haven't heard of such a case
@ervinskendaj80877 жыл бұрын
it happens to me too... did you find any thing on that???it happens at the same moment my throttle pedal gets disconnected...any ideas???
@dante44276 жыл бұрын
Air leak
@madalincoman98455 жыл бұрын
hi , i have same problem , i drive , and ESP light ON , my pedal Throttles disconect , i need to stop engine , start again and the problem sometimes disappear, for some days , and again have some problems , how do you rezolv ?
@mickfarrell59742 жыл бұрын
@@madalincoman9845 hi did you find out what was causing this my zafira is doing the same thing at the minute
@trajche_816 жыл бұрын
Hi, I know that you sold your Zafi, but just simple question. I did the cleaning procedure as presented, but now the car is going into limp mode. There is P0100 error (MAF sensor). Never had issues with it before. Reconnected and cleaned all connectors several times but all the same. Tried several times to clear the code, no luck. Do you maybe know the solution or experienced simmilar issue?
@pauliusrytmetis16882 жыл бұрын
You damaged Ecu connector.
@trajche_812 жыл бұрын
Yes, that was final outcome. After that I had ECU redone. Since then, everything has been perfect. Zafi is still rolling quite well.
@belkadelavega4 жыл бұрын
It woooorks! 😜
@user-oo6gd4vk9l3 жыл бұрын
112508 ?
@JustForTube808 жыл бұрын
Should we disconnect the battery during this time? What do you recommend to clean? wd 40 ?
@fixanddrive8 жыл бұрын
Deffinately disconnect the battery. Never use a regular wd40, this is not a cleaner. Though wd40 also produces an electrical contact cleaner. In fact, use any spray el. contact cleaner
@ton23tony788 жыл бұрын
grande gacias
@GaGa-B4 жыл бұрын
P-1125_62?
@markobaric7 жыл бұрын
Can you tell me what are those wires on nails we can see on 2:35?
@fixanddrive7 жыл бұрын
I just made a test with making a bypass on the cruise control connectors because I had problems with poor connection and sometimes i didn't have cruise control. So these are two cruise control connectors.
@markobaric7 жыл бұрын
Ok, thanks!
@vedparkashsihag786 жыл бұрын
टाटा सफारी 3 लीटर के p1120 codes
@ersatli7 жыл бұрын
türkçesini bilen yokmu
@erciodisergio6 жыл бұрын
celal coşkun hala merak ediyorsan anlatayım ben anladım