Hey Sandor, I just built my first Voron a few weeks ago and love it, I went with the 300mm 2.4 rev C kit. I do want to try the Voron 0.x that you did. Once you do all of the input shaping / PA (and other) calibrations, it will print great. I'm loving the quality I'm getting. Make sure to save your config after doing those so it saves into your printer.cfg, that way you don't need to do anything in the Slicer. Klipper takes getting used to, but once you figure it out, it's pretty self-explanatory. Thankfully there's a ton of help out there to figure things out. Orca Slicer works great with the Vorons and is what I'm using. * Quick tip, make sure you don't save your PA value to your printer.cfg AND turn PA ON in the Slicer, prints will not be good haha.