VZ Front Motormounts - timelapse
Рет қаралды 1,315
![Klaus-Michael [KMS]](http://yt3.ggpht.com/ytc/AIdro_mkUjDoeaHdWU0tyH0kzO7fdOj0faGkvQMcpsiucZWYFA=s48-c-k-c0x00ffffff-no-rj)
Жыл бұрынplayed at 800% speed.
I machined the left and right part at the same time with two work coordinate systems in two vices (to reduce tool change times). This video shows the vice holding the left part during the first two operations. The last two operations were running in the same vice, that's why you are seeing two parts during the end.
Daten zur Fräse:
20er CPC Schienen mit hoher Vorspannung, 100x70x40cm
Dakai Dual Nut Kugelumlaufspindeln Y 2005, X & Z 1605
90x90 Alu Profile Schwer für den Tisch
160x80 Alu Profile Schwer fürs Portal
Portalwangen aus S235JR Stahl
Kreuzplatte und Z-Achse aus 5083 Alu
RATTM 4.5KW ATC BT30 Spindel + 5.5KW Fuling VFD
PlanetCNC TNGv2
Daten zur Drehe:
Paulimot SIEG SC4
Z-Achse: 2005 KUS + JMC CL 3NM
X-Achse: 1204er KUS + JMC CL 3NM
Steuerung: PlanetCNC TNGv2
@alessandrofabiano6734 Жыл бұрын
Immerwieder Toll deine Maschine in Action zu sehen. Sieht nach sehr viel Vorarbeit aus.
@DBProto Жыл бұрын
I appreciate that you list your feeds and speeds for all ops very much.
@JBWorx Жыл бұрын
Good job on the small slot, it’s rather deep for that tool.
@KlausMichaelKMS Жыл бұрын
Thanks. Yea I was not 100% sure if it would work out fine. 3 times deep is always a bit risky. A good endmill, good feeds and speeds and enough coolant did the trick
@fastfred6372 Жыл бұрын
Es flutscht aber schon ordentlich 🦾
@josef.hofbauer3597 Жыл бұрын
Lass dich mal wieder sehen
@KlausMichaelKMS Жыл бұрын
Ja ist geplant. Nur die Zeit spielt aktuell nicht so mit.
Wrecker
Рет қаралды 572 М.