Starting to look like an appliance repair channel. Just all my appliances decided to have problems at the same time!

Great Video. I bought a cheap solder/desolder kit, and the relays. I got two relays because the one next to the one shown in the video checked bad also. So, 20 dollars for the kit and 5 for the relays and 20 for expediting the two orders and washer is draining again. A suggestion is to find the service technician instructions that are taped to the inside of one of the washer sides. They explain diagnostic tests and have a wiring diagram I found helpful.

I bought one of these used and the guy said it worked fine. It did not, in fact, work fine. Drain would never turn on. Checked for power at the drain, got nothing. Checked the relay, and it was blown, just like this one. Problem is I don't have any soldering tools, and the labor to have someone do it + the relay would have been more than the 50 bucks to get a used control board off ebay, so I said screw it and just went the ebay route. This really helped me diagnose things, though, so I really appreciate it. I looked everywhere for a good video, and yours was no BS and straight to the point.

Well done 👍 This is a good channel !

Thanks! I have a mower with that battery

Great Video! What are the part numbers for the other relays? It looks like two types are on the board?

My circulation pump is 24.5 OMS is good or bad I connect directly to 120 and is working

Do you have a relay layout? Can find a k1-kx listing for function to make sure I'm replacing the right one. My contacts are sticking after it runs a few cycles and the drain pump won't turn off.

I have the exact one but mines, my drain keeps running once its finished. I changed to pump 3x already but still does it. Dont know what to check

I watched a guys video about fixing trailblazer cluster and clicked on your link. I do a lot of washer dryer repair and have junked some that need board repair because of the huge price they want for a new board. Do you repair most types of boards?

Idk how much you know about washers but i have a whirlpool cabrio platinum and I get the ld error which is long drain idk if it's because I had the wrong pump sent to me like it it the wrong pump and still fits would it work or not work. The whole washer was taken apart and cleaned out to be sure nothing was clogging it . Tested the wires from the board to the pump motor and that's all good it's I even tested from the back of the board to before its getting ohms to the board so idk if its cuz it maybe the wrong pump it looks the same as the original pump or less it just a bad pump also it was working was doing a load of laundry then it stopped and said ld on the screen. Did diagnostic test and c8 and c9 won't work but everything else works before it gets to c8 and c9. I have another pump coming in tomorrow that ik is the one for my washer. The other one has same part number as my original one but I looked it up and says its.not for my model. But fits so idk if that could be why new one isn't working so I'd figured I'd ask you to see if you would know or could help me out. Thank you