Learn how to install your new High Impact Protection tape on your bike. Wilderwild's Protection Tape can be used for a variety of applications including cars, skis, kayaks, motorcycles and more! Application surfaces included aluminum, carbon fiber, steel, glass, plastics, painted and powder-coated surfaces.
Installation Instructions: Wash hands and surface with soapy water to avoid contaminants and fingerprints on the adhesive. 50/50 Isopropyl Alcohol can be used for surface preparation, this will soften the adhesive and create an instant bond. Wilderwild’s High Impact Protection Tape can be installed wet or dry. It is recommended to install the tape on a wet surface so you can easily make positioning adjustments. When installing on angles or bends use a heat gun (on low) or hair dryer to activate the glue. Using the provided squeegee, in a pulling motion remove solution between the tape and surface, with a pushing motion use the squeegee to compress the film and remove bubbles. Ambient and surface temperature for install must be between 55°F and 90°F.
Removal Instructions: For best results, we recommend using a steamer to remove the adhesive tape. DO NOT REMOVE the tape without properly heating the High Impact Protection Tape first. A heat gun (on low) or hair dryer can be used to soften the adhesive. This method may cause the adhesive to split which will require more adhesive to be cleaned off the surface.
www.wilderwildllc.com