WOW! RTI Prophet 2 PCP air rifle with JSB slugs ONE MOA!

Рет қаралды 6,067

Жыл бұрын

Finally I managed one MOA with one of my guns. Didn't succeed with LCS at 100m. With the RTI Prophet II out of the box it worked!

Пікірлер: 33

@leosairguns Жыл бұрын

Nice grouping with the Knockout slugs, I've always said those slugs are great! My Maverick does really well with them, and so far I haven't found any other better slug. Subed to your channel brother! Keep up the good work!! 👍🏼

@AirgunNL Жыл бұрын

Thanks a lot

@MNhunter88 Жыл бұрын

Good grouping 👍👍

@aritonanghunter3831 Жыл бұрын

Good job..my frend...

@bokiminor5089 Жыл бұрын

It is nice gruping, the grup is higher because the slug have better BC than pellet. So what was the identified fault that the air was leaking?

@AirgunNL Жыл бұрын

I know. The BC was set at 10,4 but still going high. With pellets set to +/- 4,5 it works great. The fault was o-ring inside the valve cylinder. Check my other video and www.rtiarms.shop/products/spare-parts-rti-prophet-ii

@bokiminor5089 Жыл бұрын

Yes, I was watching an enjoyed too. It is nice done. It is strong and precise tihis pcp.

@mikebenoit6648 Жыл бұрын

Will Slugs 22caliber work with a Quest Nite Ops Air Rifle from Crossman

@AirgunNL Жыл бұрын

Don't know

@garymurray5361 Жыл бұрын

Good video 👍. What jsb were you using, 217 or 216?. I've had good groups with Zan 23 gr, weather stops play for now. Knock out testing next.

@AirgunNL Жыл бұрын

33,49gr 6.37mm knockouts Mk1

@garymurray5361 Жыл бұрын

@@AirgunNL great group. An apology, I thought you were shooting 5.5. i must wake up properly before watching in future.

@AirgunNL Жыл бұрын

@@garymurray5361 don't think I mentioned it specifically...😁

@carllarkylark Жыл бұрын

That's a great first group's. Is that a .22 or .25? That is thier new barrel right?

@AirgunNL Жыл бұрын

.25, yes the new barrel...

@northeastverminhunters Жыл бұрын

im using the H&N 28g 249 slugs in .25 at around 970fps and there grouping very well

@AirgunNL Жыл бұрын

Ok I have those somewhere too. I will try them soon.

@lars7948 Жыл бұрын

what is the the reg. pressure ? Hammer spring tension "Factory" ?

@AirgunNL Жыл бұрын

155 bar and about factory spring tension. Not sure since I took it apart.

@AirgunNL Жыл бұрын

Actually the hammer spring should not be adjusted. You should find the spot where the valve just opens and then rotate it about 1/2 turn extra in. This makes the hamer less impacting the valve and the gun more accurate.

@markhall7735 Жыл бұрын

What Speed in FPS did find Knockouts best at

@AirgunNL Жыл бұрын

I did not make a lot of adjustments. I shoot them around 930fps.

@garrysmith898 Жыл бұрын

Would you say it's a better than the fx impact

@AirgunNL Жыл бұрын

Can't say. Don't have one, but it's much less complicated though...

@miljanmilivojevic4905 Жыл бұрын

It's not complicated like fx and yes I think it's better. Bravo for RTI 👌👍😀😍

@weirhauch1002 Жыл бұрын

Is this the new slug barrel?

@AirgunNL Жыл бұрын

The new RTI barrel yes. Works excellent both for pellets and slugs.

@weirhauch1002 Жыл бұрын

I modified a 700 mm CZ barrel to fit the block of my RTI prophet .It shoots almost all kinds of pellets and slugs at different speed .

@macq1980 Жыл бұрын

Is the performance edition? I want to shoot slugs to

@AirgunNL Жыл бұрын

Yes the performance edition.

@tedsell1455 Жыл бұрын

Barrel on Mine is for Light Slugs Heavy Pellets

@mauricebolier5919 Жыл бұрын

First of all your gun has way to much max spread. and how is t possible to have a bc of 10? and I wouldn't place videos with moving traffic just after your target. not doing the hobby much good