I have a 2017 stander x, 52" cut. I changed the idler arm bolt from a 3 1/2" length to a 4 inch. It let the idler pulley drop below the wheel pump pulley. It was so much easier. Bolt was $1.70. Worth every bit of the $. Lol

I have a gen 1 Wright X (also a gen1 ZK). Changing the hydro belt is a PIA. someone else made a video doing this. It looks like you have to remove a retainer bracket to unplug & move the electrical connection to the PTO. What's the best way to get this done ? should I remove the deck and hang it vertically from my front end loader ? I have 4 antique Great Dane origional Surfers. (1997-2000) They are EASY to change.

Was your platform off when u did this?

Thanks

My belt lasted 650 hrs. Is that high or low?? Nice meeting Ed at GIE 2021

hey ED do you have any videos on how to change hydro oil on a wright stander b32

Hey Ed, I bought a used ZK with 1200 hours. This machine is a beast but the idler pulley met its end while cutting my grass. What is the part number for it? Thank you Ed

Nice tip. I change my drive belt today on my 2016 32 stander. It's way easier than this. All I need is a breaker bar. Boom done!🙂👍

Tx

Holy shot i have watched this 20 times. When you say loop around the engine you speed it up and you cant tell what the fuck is happening. Do you understand that this is the hardest part for a novice/ landscaping mechanic? Cmon man seriously….

Ok? Next step i will time lapse so you cant tell what direction im spinning anything… k? And next… k? Lol how stupid do have to be to speed up the instructions lol