Wurth Stone Chip and Underbody Protection

Рет қаралды 73,146

8 жыл бұрын

Restores the original structure of body work and helps prevent damage.
Application Process
1. Clean and dry surface
2. Load your Wurth spray gun
3. Spray to desired level of thickness
Tips & Tricks
Since this product needs to be applied to a clean surface, try Wurth's Silicone Remover for cleaning!
Clean your spray gun after use with Wurth's Universal Thinner!

Пікірлер: 10

@miketaylor7440 3 жыл бұрын

Just about to apply this to the sills and floorpans of my 1989 944 to top up the original stuff Porsche put on 31 years ago. The fact the car is even here still is testament to this rubberised rust preventer. If there’s a gap in the rubberised stuff and water gets to the metal it’ll rust and why wouldn’t it? If you regularly maintain and repair the underbody finish the car will last indefinitely.

@wrdjr10gmail 7 жыл бұрын

if you are considering A Quality Repair you will watch this among others

@buffi944 4 жыл бұрын

rubbish product causes more problems in the future

@C0ckZilla 3 жыл бұрын

Sir any reason why? I'm just planning to have my car undercoat using Wurth.

@miketaylor7440 3 жыл бұрын

@@C0ckZilla don’t listen to the chump.

@adrianTNT 2 жыл бұрын

@@C0ckZilla he probably means rust can still advance if present when applying this, and you cannot see what is underneath rubber until it is way too late.

@noelvanbilsen6405 2 жыл бұрын

@@adrianTNT What do you recomment?

@nathansharma87 2 жыл бұрын

@@C0ckZilla the rubber acts like a skin over the metal. Just like if you were to put a sheet of cling film on your arm. Over time it sweats in between the rubber and the metal. With changes in the weather, humidity and heat as well as rain more and more moisture builds up between the rubber skin and the vehicles body which not only creates rust but significantly advances it. This is why rubberised coatings have all but disappeared from the limelight. The newer coatings which are recommended are bitumen or paint based that use a solvent as a vessel. It sprays on, the solvent evaporates leaving behind a tough, durable finish that is bonded to the metal and won't separate or have spaces between it for moisture to build or sit.