Good tips, My cg on the battery was different placement due to the RC Geek afterburner set up installed. It was better for me to have the receiver in the aft section as well. I will do all other tips and thanks for them. Enjoyed watching.
@NoonzAirborneRC8 ай бұрын
Yup! I originally had the rx in the rear. But I could not move my lipo back enough. Good deal on the afterburner adding ballast. That way no extensions needed and easier to do! Great info Tug! 👊🇺🇸
@nirlachman0078 ай бұрын
Nice tips Nunez but all those tips are absolutely pointing on some flaws of engineering for this jet :(
@NoonzAirborneRC8 ай бұрын
Negative jet Flys fine stock on stock gyro. This is for people who are altering stock setup. The front gear landing light is simple. Like none of us had to do it on a freewing or eflite b4. Hahaha Thanks for watching 🇺🇸👊
@scottmccluskey80554 ай бұрын
Hey Noonz great vid but in bypass mode how can the on board gyro affect the added gyro if the wiring is completely disconnected from the on board gyro?
@NoonzAirborneRC4 ай бұрын
In Bypass mode. Tou are shutting off the board gyro and only using the gyro on the rx.
@scottmccluskey80554 ай бұрын
Correct so in the video you say make sure the on board gyro is off otherwise the 2 gyros will interfere with each other. How could that happen if the surfaces are not connected to the onboard gyro? Also if in bypass using your own gyro why is the rudder still left connected to the on board gyro?
@NoonzAirborneRC4 ай бұрын
@scottmccluskey8055 in my video you would notice I didn't bypass my rudder. I didn't c a re if I had rudder stabalized just ail and ele. This is why to have it off. Also another point...if it's bypassed why even have it on? I said have it off also for the resom to negate someone doing idk what and saying I caused the crash with advice (yes those "people" are out there) thanks so much for you questions 👍👊🇺🇲
@scottmccluskey80554 ай бұрын
Ok yes that makes sense. Cheers for your video and tips. thankyou 👍🏻🇦🇺