A TWO part series converting Y33 to S chassis front coilovers, knuckles hubs, z32 brakes. Everything you need to know! Follow Me! Instagram- Mikeg203
Пікірлер: 20
@reproducable Жыл бұрын
what a rollercoaster of emotion about that swaybar. really nice to see your thoroughness about documenting the procedure. already seen the reel and the finished product looks so clean! keep it up mike!
@Noodypics. Жыл бұрын
Mikey keep up the f**Kim good work my g
@zahnstevenson123 Жыл бұрын
I got in touch with a local guy here in NZ about what he used on his Y33 gloria a while back in regard to wanting to do it myself, And apparently he used the sway bar ends off a z32 and spliced them onto the ends of the y33 sway bar. idk how accurate that sounds but could be worth comparing ends
@go7662 Жыл бұрын
thank you for this
@whitedriveofficial16343 ай бұрын
Awesome great informative video man , Does this apply to y33 Gloria’s as well?
@mikegtv61643 ай бұрын
Yes it does! I actually did a Gloria as well just didn’t film it!
@callumsharman5536 Жыл бұрын
Just a heads up what I ran into when rebuilding the y33 lower control arms! The poly bushings from s14/z32 fit but you have to burn out the rubber bushing and keep the original bushing sleeve in the control arm! I made the mistake of pressing out the bushing and the poly one was to loose. 👍🏼
@mikegtv6164 Жыл бұрын
Yes I noticed that in the energy kit it says to keep the sleeve I found that strange and made it more of a pain because I can’t press them out
@originalweedy Жыл бұрын
I have a 90s junk air freshener on my y33 rear view mirror
@villains91 Жыл бұрын
You can run adjustable sway bar end links from what I’ve been told
@mikegtv6164 Жыл бұрын
Yes if you weld mounts on the s14 lowers
@alandisellis896911 ай бұрын
So I can use S14 coilvers with S14 knuckels with BC lower mount and S14 hub ?
@motutengz957610 ай бұрын
Hey bro what’d you end up running a bit confused asw and attempting to give it a go myself as well lol
@josephdominguez5827 Жыл бұрын
what set up were you running before the s chasis swap
@mikegtv6164 Жыл бұрын
It is the mono ss same as bc weld in knuckle setup. Still running the the same coilover just replaced the lower mount to a s14 mount.
@josephdominguez5827 Жыл бұрын
@@mikegtv6164 do i have to weld anything to install mine? i’m lost in what i need to do to lower mine
@mikegtv6164 Жыл бұрын
I have another video showing how to lower with the normal y33 coils that you have to weld the lowers with. I do have the lower welded spindles aval that I will sell so you wouldn’t have to weld yours
@johnnynephew1044Ай бұрын
Did the stock Y33 tension rods work fine?
@mikegtv6164Ай бұрын
Yes
@johnnynephew1044Ай бұрын
@@mikegtv6164Awesome this makes my life easier lol also the Y33 control arm bushings are the same as S14 bushings or no? I can’t find any energy suspension ones for the Y33