Jon Hughes

Пікірлер

@jeffreyport1099 Күн бұрын

Help? Fan runs Backwards and blows the heat/cold from outside to inside my bathroom. I had the same vent fan light combo wired into my bathroom to replace the old single bulb. It is wired into the light switch, so when you turn on the light switch, light and fan come on at same time. Hope someone can help.

@Jonehughes Күн бұрын

Hi Jeffrey Since those fan motors cannot run backwards The only thing I can suggest is you have an obstruction Double check that the flapper opens all the way open and if not an obstruction there and then in the pipe there's no obstruction in the pipe either because something is pushing the air back and it's not the fan

@Jonehughes Күн бұрын

Check the video at 5 minutes and 45 seconds and watch the flapper move

@Jonehughes Күн бұрын

Let us know if it works

@jeffreyport1099 Күн бұрын

@@Jonehughes I went to bathroom with a ladder to check on the inside, but it is too high for me to get to it and check for obstructions, the outside, where the vent comes out is too far for me to see if it is blocked. It is about 11 feet high from ground level. I will see if I can get someone younger and able to walk and climb better than me. I appreciate the advice and help. ty

@RolandoAsmat 2 күн бұрын

Would this work on a cast iron pan that's already benn set? Its currently leveled with wooden shims but I feel like those will eventually break. I haven't installed the shiwer ealls yet so I still have acces to the underneath the pan.

@Jonehughes 2 күн бұрын

Heck yeah that would be great Do the hardest to reach parts first and work your way around to the easiest You don't need to weigh it down if it's cast iron It already weighs a ton That'll solidify it completely Any foam besides minimal expansion

@manueljohn1458 2 күн бұрын

👍👍....✌️.

@TuanTran-214 3 күн бұрын

Thanks for the video. Did you back fill the shower drain access with concrete? Is it necessary?

@Jonehughes 3 күн бұрын

I never backfill that hole It usually is not accessed by any humans because it's so far away from where they stand If it turned out you had a center drain Then I would double check and triple check that my plumbing is correct and set in the right spot and then back fill it with dry pack mortar Because wherever humans step even though they have naked feet There still is 100 lb on each foot But whenl they're on the left side or the right side humans can't really step over the hole it's too close to the wall so there's no reason to fill it

@NatureBoy711 4 күн бұрын

i mixed the 70 percent with 99 percent alcohol and within 30 minutes , the can exploded with a loud bang ! what caused this ??

@catfish24 4 күн бұрын

What kinda foam did you use???? Window and door, large Crack foam, or regular foam ?????

@Jonehughes 4 күн бұрын

Don't use minimal expanding I used every single kind whatever I have available so I like big crack best but you can use anything It really doesn't matter they're all virtually the same but make sure you put tons of weight on it so it doesn't come out or up

@tradeherup 5 күн бұрын

Disagree, put nylog on the flare to brass dielectric male to female connection. If it can't leak at the seal it'll never leak on the back of the nut.

@Mike-01234 5 күн бұрын

If you read the Nylog instructions it says it's made to put on both sides of the flare to seal it better.

@Jonehughes 5 күн бұрын

Yeah I don't mind I don't have any leaks I put in seven of those in one day and never had a single leak but I hear so many people say that you shouldn't even use nylog 😂

5 күн бұрын

Just got in on Ryobi deal at Home Depot because I was going to buy an 18 Ga nailgun for baseboards and you buy a pack with three batteries for 160 and can get the 190 nailgun (brushless) free. But damn this looks so nice to add for only 60 I’m going back tomorrow. lol. Good marketing strategy by Ryobi as I’ll probably grab several cordless tools now since I have the batteries.

@Yirmeyah1 5 күн бұрын

Thanks. Mine works fine now.

@TheShaggyfrog 9 күн бұрын

Why do so many people use tear away trim instead of just doing this? This just seems simpler. I'm trying to decide which way I'm going with our recent remodel.

@Jonehughes 9 күн бұрын

@@TheShaggyfrog send me a pic of what you're referring to I've never seen that before Jon 5416607805

@TheShaggyfrog 9 күн бұрын

@@Jonehughes actually, this 1 minute video shows it best. But your way seems simpler. kzfaq.info/get/bejne/jNmfktahtNy-oKM.htmlsi=QPUPkFadKJozzyPI

@femboy_fatale69420 9 күн бұрын

Thank you for making this! This video was extremely helpful for a complete beginner like myself.

@captmike390 10 күн бұрын

I just did a 3x4" patch with the Latex-ite wet patch. I want to seal it with this. On a small area, can you apply this with a hand trowel? Nice job. Thanks for the video.

@Jonehughes 10 күн бұрын

Yeah the hardest thing is going to be mixing it up but if you don't mind working it for a while like I use a big giant drywall mud spinner but if you don't have something like that if you're going to do with a stick or something that'll be a little brutal but it should be fine and you only got to use a paintbrush you know get a big paint brush but you could be done in 5 minutes and the hardest part is going to be stirring it if you don't have a proper spinner like a drywall mud spinner

@captmike390 10 күн бұрын

@@Jonehughes Thanks, Jon. I may look into the mud spinner. And paint brush. It does seem a little thin for a trowel.

@Youkon604 10 күн бұрын

I did not believe this would work I had two old paint rollers stuck on the cages and I thought no way will this work it worked I am so grateful thank you thank you thank you for this video

@maryblack9169 10 күн бұрын

Thank you so much!!!!!!!! Did it, and it worked! Thank you😊

@golden1_1dragon12 11 күн бұрын

i just replace the band with a metal one. problem solved and extra drip

@marcuscheko3264 14 күн бұрын

Thanks for posting.....didn't think about using a 2x4....thanks for the great idea and the ratchet strap !!

@superslugeater3289 18 күн бұрын

Thanks Jon. Helped a lot!

@mintoo2cool 18 күн бұрын

you saved me a bunch of money! thank you for the tip!

@1ndone132 24 күн бұрын

Simple & to the point thx!

@YellowwoodRidge 24 күн бұрын

Thanks Jon! Getting ready to install 230 sheets on our insulated slab for our passive inspired house.

@wflower3500 25 күн бұрын

You don't explain how to put or show me how to install the clips for shelves . I still can't figure it out.

@lorenunsworth 28 күн бұрын

I've done this twice. However both tines it fixed keak but then all the display lights come on and won't shut off.

@Jonehughes 28 күн бұрын

The display cannot be fixed It is time to get a new one

@Baconlover5280 29 күн бұрын

Parents own a big ranch and a buddy of there’s gave them a 2016 tao 150cc that don’t run and said if yall can fix it, keep it. Imma try my best to get her running

@acelticeyemmorgan2487 29 күн бұрын

Unbelievable! That was one of the best tips ever!

@slippyg Ай бұрын

I'm using a 8 foot scaffold plank but I just can't get the purchase

@danhumphrey5755 Ай бұрын

USELESS! About the stupidest diy video I've seen.

@Denman500. Ай бұрын

I changed the pump on my ruck, at 1102 miles.

@PFK617 Ай бұрын

I never left mine out in the winter, but the white screw thing was gapping. Your directions did the trick. Thank you!

@deankay4434 Ай бұрын

It is great to hear someone suggest barn screws with rubber washers. Just tighten until the rubber washer starts to seal. Nails will pop even sealant last 3-5yrs. then cracks. Screws do not in-screw and makes sense. The bottom half of any roof penetration has to be over the lower shingles. If not a leak will occur in 3-5 yrs. guaranteed. A lamp circuit will work but measure the amps your fan pulls. If soft vents are not clogged with spider webs, cotton-wood tree seeds and other, ampere will go up as they work harder. Use a roof vent with matching shingles can retrofit the roof. Just make sure the soffit vents are not clogged with too much insulation. Ceiling design makes it near impossible to reach, but with vent removed, use a curly dog steak welded to pole equipped with a handle to twist in and grab blocking installation and pull out. Save And place back in attic. Just writing out loud! Not a pro-roofer but someone who pays attention to air circulation in the attic to allow lower utility bills and lower attic temps that "Cook Shingles" from underneath! It makes a huge difference! Mechanically home owner. Great video, thanks by adding value to this subject that allows longer roof life & lower utilities. That is money gone, so reduce it by $50 per month during your hotter seasons puts $1,000 to $2,000 per year. But more fuel, better food, put money into savings account #2 for car repair or home appliances, medical or other emergencies. Life is full of those, so pay yourself first, then bills and maintain a healthy savings #1. No law against two savings accounts! Use it! Put $100 a month in savings #2, your have $1,200 dollars for tires, furnace repair, water softener failure, etc.

@gavinorr Ай бұрын

I was convinced that I had been supplied with the wrong base - it took me ages to get the right alignment and pressure to get the base to lock, but I got there eventually.

@tadourm Ай бұрын

Thank you brother. I needed to know how to do this and your video is perfect. And oh yes ,Jesus is Lord!!

@AnnetteT-nb6gv Ай бұрын

I know a Christian carpenter who accidently cut off one of his fingers. What is the Bible's answer? '...if you are wise, you are wise for yourself, and if you scoff, you alone shall bear it.' Proverbs 9:12

@AnnetteT-nb6gv Ай бұрын

Wow, those fingers seemed awfully close to the spinning blade and where did the blade guard go?

@omarromero-gutierrez6891 Ай бұрын

Very good VIDEO THANK YOU

@wyominghome4857 Ай бұрын

I would think that detergent would have the added benefit of breaking any soil surface tension that's preventing the soil from quickly absorbing water. I have a problem with that here in Wyoming.

@captaindrywall Ай бұрын

Most helpful

@Kazz715 Ай бұрын

This guy sounds like he would be fun to work with. Wish all the people that I had to take instruction from had his disposition. Thank you for showing me how to use my new tool I bought :)

@stevesullivan9791 Ай бұрын

Thank you for making this simple! This is prob the 4th video I’ve watched on this, and all the others are using tools that would only be used by people who do this for a living. Obviously a weekend warrior is not going to have any of those tools, and is t going to spend the money to use them once. A simple 12 inch scrap of top rail with holes drilled in each end and a long screwdriver got the job done!

@BritgirlTX Ай бұрын

watching this in 2024 ... you dont need a rubber mallet any more. The recessed part of the wand is longer now, so easily fits into the previous wand. Also now they have plastic anchor straps you can attach to the wall to prevent them tipping. Nice sturdy shelving unit.

@charleyharms6546 Ай бұрын

What about the bed

@Jonehughes Ай бұрын

If you go to my page you can look through 30 different videos of setting the bed

@Jonehughes Ай бұрын

I just replied and apparently I can't find my reply so anyway go to my page and you'll find several videos that show how to set the bed

@Here-2-Learn Ай бұрын

How much are they?

@kurtgoodwin9490 Ай бұрын

Clear, quick and tro the point. good video thanks

@marcellaward2282 2 ай бұрын

This was super easy and worked like a CHARM! I threw away my roller and arm because I could not get it off, so when I read this I dug it out of the trash and 2 seconds later, it was off! Thank you!

@dcavic6157 2 ай бұрын

Soooo how fuked am I if the drywall is flushed with the shower flange? I cut out everything I could to the studs to get the shower in the bugga. Do I just mud over it with some tape from the sheet rock to the flange?