just check ur local area’s water supply

All these youngins out there with the “it’s called solder and fittings”. Well as you gain experience, you’ll come to know that in a lot of multifamily situations you cannot simply shut the water off and make a repair. There has to be notice given etc etc. So a temp solution is always the answer in those cases, to help your customer and stop the bleeding, until a permanent fix can be applied.

Just imagine what you’re doing to those pipes.

Outstanding. Could not figure how to fix towel rack. After seeing this video, it was walk in a park. Great work! Thank you!

Great video, thank you for your hassle!

I hope it works. Nothing else does.

Gasoline works better

The long hair 😂

That's the cleaner I need...it cleans the whole pipe as it goes down...I had it once an cant fine it again

Step 1. order Chinese takeout Step 2. save the chopsticks Step 3. use chopticks to fill holes Step 4. thank me

Lo mejor es ver cómo se va el ACEITE al drenaje Ojete

What about other wasps coming back to nest while your holding tumbler 🥃

Thank you very much it helped me a lot 👍🏽👍🏽

$26.654

Bro likes to be the real flying fish💀

how'd you make that?

Wait is that the meme

Wtf no gloves? Nasty

This victim mentality is not acceptable ever. Do not waste peoples time.

2033 toliet plungger

He put his hand right in that 😮😮😮😮

Messy stuff.

Plz tell us this rain water not actually full poop

Everything reminds me of her 😞

Fill the tank with hot water. Much easier.

My rubber tubing came off and now it stopped trickling how do yu make it again or does it have to?

Clean out the freaking hair!

Not work 😂

Looks good from here

Um how tight those are? I live on rent, it doesent bother me that much but would be nice to not have to push that thin up and to get nice smooth water cone out.

I tie this tape around bamboo sticks and stagger them down certain rows of seeds in my garden after I’m done planting. The birds hate this stuff. Now they don’t pick out the seedlings. It works because in the sun it’s very bright and shiny, birds can’t stand it but add wind to that and the tape flutters and makes a sound to.

Rumour has it that the drill never made it the next lift. RIP Drill

Can't stand plungers laying around 🤦‍♀️call me sicko! Put toilet brush into strong plastic bag or two turned inside out, plunge. Take clean toilet brush out of bags, replace in holder, turn plastic bags right side in if you chose inside out, seal and dispose with gloves. Clean toilet, throw up into clean toilet, then clean🤣✌️💕

Cheapest and most effective way is to watch a video on how to clean out the pea trap. It will fix all of your problems on a sink.

Hvac guys will tell you anything to sell you the newest model

I practice brazing holes like that in school . Idk if it would hold but I can braze it lol.

😂😂😂😂😂😂

What size drill bit did you?

Way da go really proud of you getting rid of them demons

Will they even allow you to get that close? 😅

How hard could it have been to just strip the black sheeting off lol .. yes it’s all copper and as long as it wired correctly it works lol … but it only takes 30 more seconds to not do a half 🫏 job 😂 Unless they used black wire as ground all the way back to the panel box … in that case they should please stop doing electrical work 🤡

These us sockets are a joke, not been any update last 20 years. Screws terminals take so much time.

How about solder the pipe. Just an idea

Don’t do this if you live in a two story and that clog is on the second floor. Goes for toilets too. The pipes between my first and second floor can’t handle plunger pressure and leak into the first floor ceiling. I used a drain weasel for my clog and good as new.

“Oh shoot, I missed.”

Take that rag off your face

Great !!!!

From a 10+ working house wife, I know how much to pour straight from the jug, dont want to waste money? Stop using dryer sheets or unhook your hot water spout. Cold water wash is just fine. What ticked me off is watered down detergent AND they not filling bottles all the way so I dont care, I will pour whats supposed to be in the jug before buying! Then the government decided to give us "energy efficient" washer & dryers that only slosh the clothes around, you might as well just use a stick and bathtub 😒😒😒😒

im a mechanic but i still know that stuff corrodes piped

A lot of people buy the wrong and cheapest plunger. Spend a couple of dollars on the right one and you will save a lot of money.