Whats the use demonstrating how to make the flat white while you block our view filming
@HungNguyen-zg4zd6 күн бұрын
What about the felt washer? I almost tear it apart. What can be used in its place?
@gidsir22998 күн бұрын
5:13 - NO, NO, NO, NO!!!!!!!!!!!! THIS VIDEO SHOULD BE BANNED -----DO NOT USE A VACUUM!!!!!!!!! - There is a felt-washer and a small/thin aluminium washer underneath the lower impeller that will easily get sucked in and deform which is impossible to fix ("The French Review" guy does not mention this, why??) Also, Sage/Breville will not sell you these as replacement parts and you might as well just put the machine in the bin! Without these washers coffee ingress will accumulate inside the machine where open electric circuits create fire risk since coffee dust is combustible. Furthermore, coffee ingress could access internal gears and cause build up in mechanical pressure and result in sharp metal debris become airborne (although second scenarios is less likely due to lower rpm)
@tolbertgaming275217 күн бұрын
have to agree that portafilter holder is just bad. i recommend using dosing cup to help with mess.also have noticed that sometimes grinder holds bit of grounds and spits it out and messes up your dosing. otherwise has been very good coffee you can pull out of it
@jean-lucbernhardt854520 күн бұрын
Elle est sous-estimée, parce que le mode d'emploi est inexistant, ou peu clair. Cela fait deux semaines que j'ai cette machine, et malgré les centaines de vidéo regardées, je n'ai pas réussi à résoudre ce pb : quelquefois elle me fait un café à 6 de pression, d'autres fois à 10, et je ne comprends toujours pas d'où vient mon erreur (probable). Mon Nespresso est plus simple. C'est pire qu'un nouvel ordinateur It is underestimated, because the instructions for use are non-existent or unclear 👎. I've had this machine for two weeks, and despite watching hundreds of videos, I haven't been able to access this problem : sometimes the machine makes me a coffee at 6 bars pressure, other times at 10 bars, and I still don't understand where my (probable) mistake comes from. My Nespresso is simpler 🤣. It's worse than a new computer
@ac2793423 күн бұрын
NanoFoamer Lithium is the best for frothing milk
@ehsan1189Ай бұрын
Where is your felt washer?
@robertpapps3618Ай бұрын
I brew in an insulated mug and pour it into the Aeropress and press it out, 2-minute brew time, works great
@billinrioАй бұрын
You failed to try the Prismo using a paper filter. The paper filter will remove the acidity that you don't like.
@alicefindlay3464Ай бұрын
Thank you for this. I am very proud of managing to clean my machine, although I had to buy a socket wrench first😂
@danielg3776Ай бұрын
Great review. Does the weighing scales come with it or where did you buy that?
@holgermauritzen33232 ай бұрын
Sorry, but omitting to mention the felt-washer and the extra washer at the bottom makes this video unusable. Following your video caused me to ruin the felt-washer as i thought it was not supposed to be there. I will recommend following another video instead.
@freightdawg67622 ай бұрын
The grinder spins when removing the nut
@truthbknown49573 ай бұрын
The Prismo can't make an espresso. I have one and I have tried but it can't. I keep it with my espresso to go.
@harbinguy13 ай бұрын
is there an auto power-off function in this machine?
@diasone3 ай бұрын
Le câble est très court aussi
@justsayin77043 ай бұрын
First, use the product the proper way, (filter was wrong), before you find fault. Secondly, the Fellow fits tightly because there's more pressure because of the valve. "It doesn't fit perfectly? It has more to clean?" What about any of the "mess" from any otjer method of making coffee? You lost your credibility with me.
@mortinocano1693 ай бұрын
This guy speaks with an accent inspired by at least a dozen different versions of English.
@capyboppy2 ай бұрын
Yes indeed. As well as both ‘cosmopolitan and a touch of cockney English from ‘down south’ I’m sure I detect a South African twang as well.
@VGnezdilov3 ай бұрын
Filter was attached wrong side up.. you should put the filter logo facing up, so you can see the logo when filter is in its basket or when you look though Aeropress cylinder.
@johnrieley14043 ай бұрын
Excellent, clear instructions with very good video. You are a good teacher, my Breville says thank you friend.
@JPHolbrook3 ай бұрын
Another washer below the impeller and then a fabric ring below that. Remove them before vacuuming. I like to clean out the chute from the grinding chamber that goes down to the portafilter holder/grinds container as well. This is where alot of plugging up can occur.
@johanrosenborg6784 ай бұрын
What do you think of the La Pavoni Kube Mill compared to either the Sage Smart Grinder Pro or the Eureka you mention in the video?
@upscalebohemian53724 ай бұрын
I don't know why people take issue with the hopper and lid. It's very good quality plastic and doesn't sound cheap and flimsy when you handle it. I got the smoked black version ("Fume" they call it at Eureka) and it's beautiful, and gives the grinder an interesting all black silhouette. These days you can also buy an optional metal or wood lid for the hopper from Eureka if you prefer. They also offer the "cleaning kit" which is essentially a round hopper with a black bellows that gives a different look and blows out coffee retention. I honestly wonder what the people who don't like this kind of quality plastic would prefer. Glass? Glass breaks. I also never bother to tighten the screw after I insert the hopper after monthly cleaning and it's a snug fit and doesn't wobble or sound cheap and hollow.
@markjohn14514 ай бұрын
Is the coffee press you used included? Why do you not use the one attached to the machine? Also are you aware the sound cuts out during your video?
@love4all8535 ай бұрын
Hi thanks for the video. But isn't there felt ring at the bottom of grinder? Mine has one but yours don't. Wondering if I could remove it
@7531monkey5 ай бұрын
Its fun to see how people lived before you could buy bellows for this grinder.
@allansmith67475 ай бұрын
Pls turn off thr machine next time b4 u do a deep clean, if u still love your fingers
@ek.74.9145 ай бұрын
HOLY OVEREXTRACTED ESPRESSO BATMAN!
@340Roznuw5 ай бұрын
Sehr Gute Anleitung
@stephendenagy33965 ай бұрын
Honestly worthless review. Why would you think that a metal filter is similar to a paper filter? Did you try different grinds? It is possible that the paper filter removes some volatile organics. A little more work please? For me, I will use my espresso machine. When traveling, I will figure the grind needed to make a proper extraction and take this with me. Not messing with paper means I will never be without coffee, even in difficult situations. There are environmental issues as well, more paper waste, etc. But as usual, to each his own!
@NoZenith5 ай бұрын
I opted for the Niche Zero for the simplicity of daily use and maintenance as well as the quietness and lower pitch while grinding. This is what I was benchmarking while shopping though and my friend just bought a Breville SGP so I'm looking up info for him as he has NO experience and doesn't live near enough for me to give him lessons 😂
@friedozzy55195 ай бұрын
You say in this video to undo the nut you must go anti clockwise. By the sound of the ratchet when you were undoing it and also the looks when you were doing it by hand you was going clockwise. Please correct me if I`m wrong.
@ddiesel18365 ай бұрын
is it ok to use a tootpick to remove the ground coffee in the bottom Bur? i notice after i did this, the grinder is not producing the same amount of cofee for the same setting
@YasserImam15 ай бұрын
I have a trick for you, don’t fill the hob with coffee, instead get your dose from a dose cup, adjust the grinding time +5seconds to whatever grams you are putting in, yes make it run more than it’s supposed to, then weight your coffee output and you will find exactly the same amount of grams in, almost 0-1% retention. Have been doing that for the last 2 years.
@RobFeldkamp6 ай бұрын
After a week, the insides would be full. 20 grams in and 20 grams out seems obvious. In my mind this says nothing about retention. The question i have is; how many of those 20 grams are fresh? How many of those are retained but replenished by older coffee? Or is this a stupid question?
@everybodylovesaids6 ай бұрын
Doing things by half measures typical french
@meinhendl6 ай бұрын
I completely agree !
@full_metal24527 ай бұрын
Grease the Bur and machine area where the coffee is collecting. Use a two part epoxy and bed that area to fill voids. Remove Bur after epoxy sets up. Clean grease and enjoy absolutely 0 retention.
@Mindrust697 ай бұрын
To get the impeller out - just turn the grinder upside down and it will slide out. None of this knife mastery stuff.
@rgruenhaus7 ай бұрын
$200 is not cheap! I have used my old Cuisinart mill for over 10 years and it was $48. If I didn't have a problem with that mill this Breville smart grinder would only disappoint a coffee snob!
@Ronnie_Rahman7 ай бұрын
Very well informative, Thank you!
@janossydnepthalipao42777 ай бұрын
Flatwhitenwith latte art? Lol
@villageblunder47877 ай бұрын
Video sound dissappears when making the coffee.
@jamesbolto7 ай бұрын
Yes I have the same problem!
@tbanks19677 ай бұрын
I mean honestly, if you find the Prismo filter and attachment 'hard' to put on, you're either trying to sabotage the product in your review or you've got motor issues. With that, I think the default paper filter makes better coffee than the Prismo, but no problems with the Prismo attachment.
@rasmusuhre897 ай бұрын
Great walkthrough! Very helpful. Thank you so much!
@DannyNagymusic7 ай бұрын
Was there another washer below the fan above the fabric washer thing ?
@JPHolbrook3 ай бұрын
Yes. Another washer below the impeller and the a fabric ring below that. Remove them before vacuuming.
@DannyNagymusic3 ай бұрын
@@JPHolbrook that makes sense. How could I order those parts I think I vacuumed that a while ago that’s why my grinder isn’t working well.
@JPHolbrook3 ай бұрын
@@DannyNagymusic I tried to send you the links but no go with the yt algo. The shop is called EReplacementparts. Look for SP0001577 for the washer and SP0001575 for the felt ring. I also changed out the impeller on my grinder. It was worn down. Hmmmm Breville where did that plastic go???? Yummy. There's a guy 3d printing impellers that do a better job of clearing the grinds down the chute. I'll get that when I need another replacement.
@JPHolbrook3 ай бұрын
@@DannyNagymusic sent you an email with the info.
@denniswood2317 ай бұрын
I would not pay that kind of money for that with a cheap hopper and the flimsy portafilter hopper
@jogrant38517 ай бұрын
I just went mad. haha. I can't watch this as a serious review because the guy sounds like he is doing a skit in Monty Python. I keep waiting for him to talk in his usual voice, probably British. But I love this coffee machine.
@Jb-sv5mw7 ай бұрын
I have a facile and I absolutely love it. Having so much fun with that paired with the Gaggia classic evo. Making amazing coffee
@joethompson2977 ай бұрын
I bought the prismo right before I found out the new aeropress models have a similar valve. I prefer the paper filters over the metal prismo filter