Appreciate this video

Thank you man! 12 years later! Couldn’t find the location of this thing! Lol

Thank you

White lithium is not a high temp grease. Completely wrong application. Decent brake pads should come with a high temp grease to apply to the correct spots.

AYO WTF NO JACK STANDS BRO na fr question tho like whered you put the jack stands cant think of a safe spot to put em

whats the thickness of the rotor? thank you

Hi. Do you have to deactivate the SBC system before working on your brakes?

It definitely NOT easy to get to on the 2007. And I don't have deep wells smh

I re-watched & did what you said. It worked! Thank you SO much. I also got the rotor set screw out without having to drill it out. Any tips on getting the rotor off besides lots of PB Blaster, a sledgehammer, and adjusting the e-brake in? It turns, but is still stuck on.

What did you do after removing caliper bolts to get the caliper to slide off? U really didn't say, could only see the back of ur hand. Then u said something about liquid?

Very helpful information

Thank you very much this is an older one but still a good one 2006 Saturn Vue 2.2 liter. I believe it was a 21 mm and the size versus stock versus new was the same swapped it out and no more issues replaced alternator serpentine belt battery PCV hose should be running really good for a long time now.

Been looking for a good minute your video help me out preciate it

Torque spec or not???

i remember I use to ride my friend katana then i went to a gsxr

Thanks for the help bro

Why y'all do the job and THEN show us. Recorded the job being done..

You’re the man. Short sweet to the point. Mine stopped working this morning. Finally a sensor on this thing that’s easy to get to 😂

Hmm...this must be something that carried over from the earlier S series Saturns even though those were 1.9 liter engines and these Ions are 2.2 liter ones, they go bad on those and the Ion's too apparently . I bought a cheap temp sensor for my 99' Saturn and it ran fine then 2 years later I had to replace it again because it was just a cheap part so maybe go with a higher quality sensor if you plan on keeping the car awhile.

Where do we return them to be repaired. My razor does not stay on. It does not click into place.

Why did you replace it? Any codes?

If you change that piece for a different eccentric shaft one that's not a ball it quiets it tremendously I used a brass piece of a babyliss rose gold trimmer

Just got mines about 2 months ago and after 3 uses, I tryd to switch the trimming pieces and I guess that little thing broke too cause mines is doing the same thing 🤨 for as much as these clippers cost you would think we wouldn’t have this problem

Hey is funny cause I just now purchase a 2007 ion and the guy just said the same sensor needs to be replaced that the GM dealer is charging hi I'm$300.00. so I just happen to see your video and is golden! Thank you brother!

🔥🔥🔥🔥🔥 boy you doing it.

Nice cut and vid... ✊🏾

Too bad the Siberian didn't show his face ...

Thanks bro you found it for me!!

will a wrench work to take it out and in? just curious and thanks man :)

thank you soooo much for the video. made it so much easier for me to change this in my son's car. thankuthankuthanku

thank you for posting this video!!! Thank you soooo much!!

This helped me verify the location of the ECT on my 2003 Cavalier since it has 260,000 miles and very dirty. Thanks a lot! Replacing in a few hours. It's almost the same exact Ecotec engine.

my Saturn vue doesn't start unless i use starter fluid, then shuts right Back off.what do you think it may be?

so i have a saturn ion 2.2 07 & my car was heating up at first because the fan blew out soo we got that fixed but then after 3 days counting this one my car temp went up a little meaning idk if the fan blew out again or ineeda change the thermalstat and the coolant sensor need help please.

Thanks bro bout to change mine tomorrow

What symptoms did you get to indicate it needed to be replaced? As in, did you get a code? overheating? etc.

Just replaced mine, deep socket 19mm be careful not to snap the plastic that holds the sensor, loosen like your unscrewing and egg- 3/4 socket works too but Deep socket is needed - Any advice how long it takes for the light to come off? May have more then one issue- checking codes in the AM

I love that this is short, sweet and to the point! Thanks for posting, I will be doing this for my car now! :-D

Where is located the trans oild cant find it.

Great video Andrea. I wish I would have seen this video before I went and cleaned the coolant reservoir tank. Anyways, I just ordered the part on rockauto for $9.55 total and I can't wait to put it on the car. Thanks again.

thanks for the vid

Great quick video! Thank you for sharing this. How did you know that it needed to be replaced? Did the odometer display just say "COOLANT"? My display has been showing that but the coolant level is not low so I do not know what's wrong. Any thoughts?

Wonderful. ! Glad to see the video still helping people!

Awesome thanks! I have an 04 Saturn Ion with 94k miles and that silly light has been an nuissance since March 2014! Never a leak, never low. I'll look for that tomorrow!

Great engine got my low coolant sensor out too lite has been on since I've had it , but really doesn't have low coolant , my l200 ecotec 4cyl (SAME ENGINE) has 279,000 miles on it still going strong seen a video of a guy who had - a utube video of his hitting 300,000 now has about 315,000 awsome huh , my car gets driven very calmly no jackrabbit take offs or hard stops and scheduled oil changes frequently I'm jay hit me up at 3615635336 or 3614464487 love to talk about saturns outa CCTX

Really appreciate this! I've got a Chilton manual, but it wasn't very clear on where the sensor was located. Helped me a ton!

thats the thermostat, it controls the input of coolant to ur engine. if its stuck closed, this will happen. if its stuck open, your car will run cold.

not sure which that would be.. i'm not a mechanic. my profession is in computers.. so I always let midas or someone do the the diagnostic, then I double check what they're saying for me that's a win win. " no one has ever been able to do anything that I couldn't learn how to do if taught properly "

yea sir. no problem. glad to be of help.

Still haven't a problem again. Works still. Cost me 140 . and they recommend getting new keys made.