1953 Allis chalmers B Clutch Installation

Рет қаралды 2,481

JPN76

Жыл бұрын

Installing the Clutch components getting ready for assembly day.

Пікірлер: 19

@michaelmiser4427 Жыл бұрын

I can’t wait to see this B assembled I actually have a C that I want to restore thank you for the content

@JPN76 Жыл бұрын

You are welcome. Hope they help with your restoration

@chrisheffernan6600 11 ай бұрын

My clutch fork was worn almost all the way through the one side, also the clutch pin was worn 1/2 way through. I tried to buy new parts, or even used parts, unable to find them. I ended up taking to our machine shop, they welded both up, put a SS hat bushing in the clutch fork, and now its good to go. Love your thorough videos.

@JPN76 11 ай бұрын

That's a good way to do it. Thanks, I tried to be more detailed than most vids so they could help others. I didn't find much detail on KZfaq before I started this project.

@nagvajrala3824 Жыл бұрын

nice video and excellent work

@JPN76 Жыл бұрын

Thanks

@rockystevecox3999 Жыл бұрын

I have been watching this fine video, and the assembly video that follows as well. I am wondering, Maybe I missed it. Were the fingers on the clutch adjusted? I need to adjust mine.

@JPN76 Жыл бұрын

I did not adjust them. The measuments given In the book are off of a flat clutch disk and mine had springs In the way. It turned out that they were fine and all three were the correct distance from the throwout bearing once assembled. I forget if it was 1/8 or 1/4 but it was in the manual

@tractorstrainsandthings555 Жыл бұрын

Great to see you back on the B. How do you prepare the large parts exterior surface for paint?

@JPN76 Жыл бұрын

Thanks, I just made a post with pics and an explanation of what I did. Currently editing a video of most of the assembly and first fire. Stay tuned!!

@tractorstrainsandthings555 Жыл бұрын

@@JPN76 You replied to a reply I asked about your bead blasting small parts which I am currently setting up in my shop but I would like to know how you do the large parts that won't fit in the bead blaster, they look great also.

@JPN76 Жыл бұрын

Go to my channel and click the community tab and you will see a post with pics explaining how I do the large parts

@tractorstrainsandthings555 Жыл бұрын

@@JPN76 Thank you. New to youtube and didn't know about the community page. Again thanks for all your help and looking forward to the assembly of the B.