√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto √ *Do it Yourself* √ *Save Money*

Thanks. You guys have helped me repair multiple vehicles over the years! You guys rock!

Great video. I just identified a break in my wiring harness and soldered it back together. Thanks!

Like your style. Not a bunch of yammering on and useless information. Straight and to the point.

Wow I got car sick watching you take that apart. I'll have to pay to get it done. lol thank you, excellent skills you have.

Thorough attention to detail! Nice job!

Thank you!!! I had issues with the clips coming apart causing my door to jam and eventually the some of the black clips fell off! I went to a junkyard and got just the black flexi part to replace and protect the wires because my door was still functioning. Will replace tomorrow and hopefully it works! Came to find out that the harness wasn’t clipped on the bottom with the rivet and would cause the entire harness and wires to move out of place causing it to me having to manually stick in the wires back in place every time I had to close it! Thanks again!

Alternative title: how to take apart a dodge minivan

This video is an eye opener as to the labor intensive process involved to just determine and get to the cause of the problem to then replace. When the bill comes, I bet the average consumer gasps asking why so much to replace just a little motor thingee. 😲

As I watched the video trouble shooting the components seemed to get more and more imvolved/complicated and then when it came down to the issue of removing the inside door panel to access/replace the door switch I came to the conclusion that I could live without a automated door.😢 Then at the very last few seconds of the video a switch was mentioned and I looked up at the door on/off switch THAT I DID NOT KNOW EXISTED and my heart started racing when I observed it was in the OFF position. Put the switch in the ON position and my door came alive from its sleep. OMG!🎉 Always check for any switches FIRST and prevemt heart attacks.

Your Awesome all your Videos are top notch keep up the great work for 1A Auto.

Good one. I have that same problem with my 2001..

That door harness had issues in the previous body style as well. Great video i like that you go into great detail on how to do everything

Very nice work. However, I think leaving the door in manual mode ( which is the case in 99%+ of all the cars on this planet) would be the best fix seeing how complicated the repair is and how prone to failure the system would be even after repair. Thanks for the great videos.

I would have liked to see you repair the latch. I have this very issue and I was hoping to see someone troubleshoot and fix it.

After watching this , I think I'll be using the manual mode . Thanks for the info !!!

I wonder that for which features does this cable feed the door? Firstly, to slide. What's more for? Thank you so much.

I have a 2014 passenger side slider will open when buttons are pressed, but it will not lock at the lower latch when it fully opens, it makes the attempt, then the latch releases it so not locked in, and that then prevents it from closing when buttons pressed as the sensor does not see that lower latch as having the door locked into it. If I try and force it to lock at that lower latch by moving the door back and forth, it will take 3-4 attempts before the lower lock at the floor will hold the door, and when it does, it will start closing the door, but will fall short of totally sucking the rear latch ion completely, I give it a little ew push, the latch works and pulls in the door and closes as it should, no strange noises aside from the latch at the door floor when one is trying to get the door to lock to the last man rally you will hear a little clicking sound as it tries to hold the door, and then usually it fails and releases it and door sits an invoice out of the latch and sits there till aI manually closes the door and it will close properly as it should. Any ideas based on my symptoms what it may be, it does not seem like it is the door latch as it works when I manually open close.

Problem: Neither Pillar button nor the handles inside or out operated the power sliding doors, but the key fob double click worked on both doors so did the buttons in the overhead console. The fix: 9:40 switching the power sliding door master lock button, located in the overhead console. Thank you for your video.

Very interesting. thanks

Thanks.. Is there one fuse for both left and right sliding doors on the DGC 2020..?

How do you close them if they are stuck open and my battery has drained (apparently). I parked my car. Next morning went to start it, struggling to turn over but the doors opened to let kids get in but wouldn't start. Now, doors stuck open and then nothing but clicking sound. Tested battery 8%. Thanks for any help. 😟

We turned a junk yard manual slider into a power slider by putting all the guts from my power door into it, the problem is that it only opens or closes half way. No latch issues, just the door it's self opens up and stops halfway.

I have another issue with my side auto sliding door. It opens up on command, but it immediately closes without the command. Thank you for the video.

Do you a video that you replace the other part?

Cool how to video thanks

Do you know if those doors can be adjusted. I put another door on one it open and closes fine, but the gap at the back of the door is tight and the front of the door has a big gap. Seems like it needs to move forward

Do you have links to the specific parts? Having a hard time finding a new wiring harness or motor assembly on your website. Thanks for your help.

My wife brought the car home one day and said the sliding doors stopped working. Im so glad I found this video, turns out the switch up top was flipped off. 😂 Thought I was going to spending the day t-shooting

On mine both doors have the problem. Power works with key buttons and indoor ceiling buttons. It just won't open/close with pulling handle

Watched the whole video and at the very end he shows how to turn the automatic doors on and off. Mine was off!!!!! Maybe check that first???????????????

Is that for all dodge grand caravan’s?

Gracias

Im having trouble with my door not closing. Opens right back up. I done all the cleaning. Works for a while then back. Now I've moved the wiring just jiggling it. And it works again for a while. I had new part put in because it locked up. But now this is happening. Any suggestions. Probably the wiring.

Hi, I opened the car door the same time as the driver pressed the power button, and then it got locked from both inside and outside. What’s the issue?

My right slider was not locking so I replaced the actuator. Door now locks. Problem I’m having is door now will not open with handles, auto button opens and closes doors fob opens and closes door. Handle inside and outsid are the only items not opening door. I checked the wires and they are not broken and in the correct place. Could use some advise on getting handles to open door

Would that be the same case when the door (upon closing) closes halfway then opens back out? I've checked and cleaned and WD40ed wheels and rollers but no change.

Owen 2006 passeger side i did change door harness did not work after I think that It has to do with internal harness by the door

Thanks a lot ! May we hope the part 2 of this video for the latch replacement please ?

Ok but which latch? The rear latch then? I have same issue and latch failed but dont want to install the wrong one. Please answer

I just got a 2012 Chrysler Town n Country. I would prefer my side sliding doors to be manual. Is there any way to make it manual?

Can you fix that circuit? Is it stuck?

the Left Power Sliding Door Latch Cinch seems to be my issue

G m do you know why the 2013 toyota voxy sliding door don't pull in at the back

Great video. I have a bit of a different issue in that the door opens and closes perfectly from the FOB or the overhead buttons but not from the buttons by the doors (it does this on both side doors and even the back works perfect). ONLY the side doors buttons are effected and both of them won't work. Any ideas?

Mine the door opens and closes by itself. Or won't work at all. Would this fix that as well

For a person who cannot work on something like that is the car dealership to expensive or how much would it cost

How do I fix the window for that side

I have Dodge Grand Caravan 2012 the Right slide door that’s the only one didn’t locked ! Can u help me with that please!

The hard part is when the door lock is stuck in the lock position like mine. Now I have to figure out how to do all of what you did without the benefit of opening the door.

I have a dodge caravan we 2008 does go manual or not

If you have a multimeter why don't you check the wires for opens using that rather than looking for outward signs of breaks?

What scanner is that

What kind of scanner is that called

Have a video for door latch replacement? Or part number?

Greetings from germany, what is that part you pull out the cable at 5:11? mine is brocken and I don't know what it is so Iam not able to order sparte part, thx a lot

Have a video for the latch replacement? Or part number?

I'm having a similar issue. Was the latch the issue on the door? I had the same code on my 2010 Dodge Grand Caravan. Just replaced the schlep on mine and that didn't fix it.

What trim level?

Where is the problem? How fix?

My issue is that i want it in manual mode and when i open the door all the way, it electronically unlatches it self

I don’t have power doors in my 2010 Caravan, but the same door, the power lock has stopped working. I’ve suspected it was the actuator, but could it be the harness instead?

No sound or movement at all on mine removed front door lower trim unfastened four wire gray plug red wire has no power traced to dash under radio no power there either. Any clue. I used a test light tho

Could this be what's wrong with my power sliding door? It opens fine by itself but when I hit the button for it to close it makes this loud noise until i "pop" the handle and then it closes by itself. It's an 05 caravan

I have a 2010 T&C and had similar problems with my left door. Now it doesn't work at all, nor does the window. Would that most likely be the harness??

I need that complete harness. All I can find online is the drivers side sliding door. Anyone know where I can find the passenger side sliding door harness?

Wow. Nevermind

How much does it cost estimated to fix the tracks on the sliding door? And where does one take it too get that service?

Hello is there a video on how to adjust the left sliding door? When My dooor opens it rubs on the body panel. I need to adjust it out a little so it dont rub.

My doors open with remote and overhead switches but none of the lower switches work.

Hey quick question, I have a 2019 dodge grand caravan sxt. This lever button is on lock from the inside and no matter how much I push the little switch it does not want to move to unlock position which means the door doesn't open. Any ideas?

My door is stuck shut won't unlock at all HELP me please

How to open a sliding door on a 2010 Dodge Grand Caravan On the driver side it will not open automatically or in manually how do I get it open need desperate help

My 2017 grand caravan sliding door does not lock , after i lock the car with the key fob you can still pull and open the sliding door please anybody knows how to lock them for good ?

I have a 2005 Dodge Grand Caravan, both my side doors keep moving even after they are fully open, any ideas what it can be?

How in the world is this diagnosis? Because you did some continuity tests on some wires but why did you start there? “It’s most likely the latch”, why? This is just guessing. Throw parts at it, great motto for a parts company. Have a nice day.

You don't need to remove the window. Just use duct tape to one side glass and over the door to the other side.

Check fuses and get the book before you take the door apart.

I have a 2006 and my passenger slide door is locked and won't open at all. I can't unlock it to open. Any suggestions?

My door won't even open...no clicks or nothing.

this video didn't show me how to fix the issue... could have test the wire without taking all that steps.

My bloody manual override switch had been bumped. Check the easy stuff first!

Too much work and a dealer would charge big big money to fix, soooooo I just open and close it manually. 😊

That’s dodge for you 😏

Geez, thats a lot of connectors/retainers just to get to that point, might as well pay someone to do it.

Uhhh isn’t that something you did I have the same van uhmm no problems with the sliding doors

Mine is a 2010 manual sliding door it happen when it rain and have very fast winds passenger side door open normal but when try to open sliding door on passenger side it try to open but got stuck so now the rear latch wont close passenger side front door wont open now i pull handle door from inside it loose the door but at the bottom is lucked or latch is firm locked i have to push itin to shut the door try the push button to open door it pop up open but still hook dont wierd it only on right side do you have an idea it happen twice but first time it fix itself 10 minutes later

😳😳

Whoa Nellie, what a task! The easiest way to avoid all that mess is to avoid purchasing that Chrysler product without the power side doors. I bought a 2013 Caravan my wife liked from a Used-up car lot. The van lacks the power side doors. The side doors on the van maneuver so effortlessly with minimal physical effort that it indicates to me the power doors are for lazy people. The Lot owner told me another potential customer looked over the van and liked it, but not enough to buy it because it lacked the power side doors. Poor Baby!

I'm here after the stealership tried to charge me 1600 to do this.

Scotty Kilmer would just say to not buy one in the first place🤷🏻‍♂️

No, you’re wrong maybe you’re just broke may be a robber broke it

I have a 2015 Caravan with MANUAL opening doors. Never had a problem. Power side doors are for lazy people. 🤭🤗

Wow, those cars are really junk made it with cheap materials. Every thing fail

I thought the door module was underneath the rail?????