Picking up the engine block from machine shop, how to check crankshaft clearance, install crankshaft and bed plate
Пікірлер: 15
@goten3605 жыл бұрын
Bro SUUUUPER digg your vids man! Such great info I am surprised your not in the millions of views bro!!
@donniemidwestalkibass52555 жыл бұрын
Just an fyi, with these bedplates, you need an anaerobic sealant and NOT that gasket maker. The bedplate needs a "zero clearance" sealant that does NOT dry when exposed to air. Dodge charges a ridiculous amount of money for the Mopar stuff, but Permatex 51813 works amazingly.
@nikaliederks5933 жыл бұрын
Noted
@idabomb002 жыл бұрын
THANK YOU! I have been looking everywhere to figure out what gasket is supposed to go here.
@markrodriguezjr85532 жыл бұрын
What kind of manual did u use to rebuild it?
@jrdiaz61834 жыл бұрын
Where did you get the crank shaft ? Love the vids man
@MechanicalMike4 жыл бұрын
It was the original
@ryandeweese3633 жыл бұрын
Howd the engine turn out man??
@DavidTheMechanic4 жыл бұрын
Bro for as much work it takes to get down in there and the cost of replacing all of the torque to yield bolts I can't understand why you would not replace the bearings they're only like 50 bucks for the whole set
@MechanicalMike4 жыл бұрын
In retrospect, I definitely should have replaced the bearings. I was worried that if I replaced them, I'd have to machine the crankshaft and get oversized bearings.
@henrycole87052 жыл бұрын
It was still dirty when you reassembled.
@Dirtbillys4 жыл бұрын
Waist of time to rebuild if your not using new bearings...............
@jq71305 жыл бұрын
Get to the point my god !
@paulmillar47744 жыл бұрын
What was the cost of the pistons getting done for you? What should I expect to pay for that and to have the block gone over?
@Scott830164 жыл бұрын
@@paulmillar4774 cost about 150-200 for machine shop work depending on what u need done