Assembling and installing pistons back into the motor
Пікірлер: 6
@kevinmcmillin75942 жыл бұрын
I'll be doing this same job here soon myself using what appears too be the same set of aftermarket pistons/rings set (Chinese Aluminum Alloy) and also refusing my old rods since I had no problems with my bottom end...Thinking about buying an higher quality set of rings though perhaps like a set of Hastings or Clevite...I bought a set of King Rod,Main and Thrust bearings in a set all standard bore since I just plan on honing my cylinders... Was wondering how you build turned out ? Also wondering if I should buy a set of higher quality Ring compressors or does it matter ? Any input would be appreciated since this is my first build...Oh and Nice work way too take your time and be Profesional...👌🤙💪🐍♠️🇺🇲😎
@MJ-Dakota7 ай бұрын
How did your rebuild go. Is It runs good. I put new bearings in my motor but now after all that it has a wrist pin knock. So not sure if I should rebuild the pistons with new rings though ebay rings seem to be as good as the factory?
@kenjett24344 жыл бұрын
I never did a Dodge engine before but I rebuilt my share of small block Chevy 350s. Looks like you know what your doing with it.
@denisarauz22473 жыл бұрын
Forgot to mention how to install the piston next to it