Hope this video give you little idea how to remove subframe, transmissiontion, install flywheel and pressure plate.
Пікірлер: 59
@gizmosfere2 жыл бұрын
best video out there for 8th gen civic si clutch replacement. great job
@xSKLLxcodki11er4 жыл бұрын
Very good explaining everything step by step 👌🏻
@alltsab4 жыл бұрын
Thanks
@mongolk1ngl0g1c35 жыл бұрын
Great job.
@nightcoder5k5 жыл бұрын
Good job bro.
@kayang51035 жыл бұрын
Love the video
@julianelias67474 жыл бұрын
This video Is all the what i need for change my transmisión my self thank so much my Man youre the máster ✌️
@alltsab4 жыл бұрын
Please help subscribe thanks
@julianelias67474 жыл бұрын
@@alltsab yes im doit right now tanks
@buoreilly76292 жыл бұрын
THANK YOU. REAL GOOD INFO AND VIDEO
@alltsab2 жыл бұрын
Thanks
@jimmyyking10 ай бұрын
Wow. Subscribed. You make this look so easy. Just did this with the motor and tranny out and it was still hard. Zoo heev brother! Subscribed.
@alltsab10 ай бұрын
Ua tsaug nawb.
@howtodan1975 Жыл бұрын
Good job, so detailed, thanks, i have difficiulty putting back the trans, as i don't have the trans jack
@alltsab Жыл бұрын
You welcome buddy
@patrickbullock28424 жыл бұрын
What should I look for when replacing flywheel and how many times have you not had to replace one?
@essentiallites75363 жыл бұрын
No issues using the support bar on the fender to hold the engine up?
@jonathanmedina97244 жыл бұрын
Well Done Sir, how much does the labor cost?
@Hennrock8374 жыл бұрын
Excellent video! What size was the bolt you used to attach the engine support bar chains to the engine block?
@alltsab4 жыл бұрын
Sorry I'm lost here. Did you mean the bolt I used to hold the subframe?
@Hennrock8374 жыл бұрын
All Tsab No problem. I meant the bolt you used at 10:40 in the video to attach the chains.
@treyclark911 ай бұрын
W vid
@michaelaleme35187 ай бұрын
Awesome.
@Grey8522 жыл бұрын
Hey man are you in California and do this as your job? Would love to have you as my mechanic as you look like you know your way around these cars!
@jxl03184 ай бұрын
Hey brother, how much you charge to replace the clutch, clutch master and slave cylinder
@joel95ex3 жыл бұрын
good video. what kind of ratchet wrench were you using most of the video? it looked like a thin flex head wrench but with a socket on it.
@alltsab3 жыл бұрын
Buy it cheap from harbor freight
@alltsab3 жыл бұрын
Cheap but work best
@wilfreddiazvellon78964 жыл бұрын
Good job but for me it looks complicated.
@kristopherjulian36132 жыл бұрын
instablaster
@SATO_FD2R3 жыл бұрын
*_Great video! And I love the Fiji Blue Pearl Mugen!_* (๑╹◡╹)ノ"
@BubbaGumpShrimpss3 жыл бұрын
Are you located in CA and have your own shop? I would like to get my clutch replaced soon. I would do it myself but I don’t have the time or the tools.
@alltsab3 жыл бұрын
No shop I only do it for my family only
@Ok-ql1uz Жыл бұрын
How much for clutch replacement for honda accord 96
@Diego025674 жыл бұрын
Where did you attach the chain to support the engine??? Got pictures???
@alltsab4 жыл бұрын
used strap tie wrap around the tranny be careful with sensor
@FritzMadness3 жыл бұрын
hey bro, same process for the Coupe 2008?
@alltsab3 жыл бұрын
Yup
@julianelias67474 жыл бұрын
How much oil you use for this transmisión? And whats can a oil ? Thanks máster ✌️
@alltsab4 жыл бұрын
Not too sure how many quarts but pump until over Flo that all you need. Go to honda buy the manual transmission fluid ask them for s2000 tranny fluid they will sell you the exact type and amount. Ok
@julianelias67474 жыл бұрын
@@alltsab apeciate boos thanks for yoy suporte✌️
@madam4973 жыл бұрын
IDK if I can do this after watching your video. I don't have all the tools especially how I am going to hold the engine up. I might just bite the dust and pay a shop to do it. :/
@alltsab3 жыл бұрын
It's doesn't need a lot tool or special tool to do it. As long you know how to follow instructions and have a lot patient about it.
@madam4973 жыл бұрын
Advice on dropping down the transmission without a transmission jack? I am at the 15 minute mark of your video. Thanks
@_cyang3 жыл бұрын
How do you install transmission back to engine?
@alltsab3 жыл бұрын
Did you watch the video?
@_cyang3 жыл бұрын
All Tsab yes i followed all your step doing my own clutch but i just cant align the transmission to the engine
@alltsab3 жыл бұрын
@@_cyang remember in the video used long bolt to help alignment the transmission pin holder. Used long bolts to hold the transmission so you just slide it in.
@_cyang3 жыл бұрын
All Tsab how do you get the two holes so close to each other to connect?
@alltsab3 жыл бұрын
@@_cyang if you align with long bolts slow yank it and push it will go in. Did you used alignment tool to align you clutch?
@briang34873 жыл бұрын
Which clutch kit?
@alltsab3 жыл бұрын
Exedy clutch kit
@robertorodriguez7629 Жыл бұрын
when you have all the tools it's easy😅 maybee
@MINAR3L_GR3Y_2V2 жыл бұрын
How much does a job like this cost?
@alltsab2 жыл бұрын
Different shops place Different prices. Myself just a case of beer
@MINAR3L_GR3Y_2V2 жыл бұрын
@@alltsab my civic si is in need of a new clutch at the moment lol