Stranger things have happened bud, how many motors are there they’re not working? Anyway have you re-tried your testing with the power making sure that your connections were OK? And don’t forget sometimes continuity test aren’t as accurate as you assume them to be!

@@bigfootemobileauto9734 three motors none work I also checked the power in and out switch back probing if I remember, I also tried jumping motors directly nothing passenger seat work properly of course the seat died when it was slide all they way up so getting it out was a chore because front bolts were not accessible had to drill a hole into seat track to access bolt then I was able to make sure I had power at the main connector in the trough power all the way in and out if I remember. I removed the front to back motor and used my drill on the spline and was able to put the seat in the position where my daughter drives but I would like to fix it..is there a seat control module some where I have a partial schematic of the circuit. If I put 12 v directly to motor shouldn't it spin? Thanks in advance

I thought the same thing Jim but those meter probes from the back of the harness probably weren’t damaging much!

Lol. I have other leads, but your right. They actually fit in there without hurting anything