3D printed Ball and Socket
Рет қаралды 96,104
7 жыл бұрын3D printed ball and socket with a few options for a flexible system.
All the files can be found below as well as some instructions/notes at the Thingiverse link below
www.thingiverse.com/thing:2069128
coder-tronics.com/
@CoderTronics 2 жыл бұрын
Yep agree PETG or Nylon as stronger and more forgiving. I used too higher temperature when printing these in PLA so they are little brittle lowering it a bit would improve them.
@hashasbashbash2724 2 жыл бұрын
is it slightly shaped like a cone so the the nut tightens more and more the further down you go? or is it just a cylinder?
@Lukebussnick 7 жыл бұрын
Nice! Are the threads modeled in or did you use a tap and die afterwards? If they are modeled/printed in, any recommendations on clearances, pitch, etc.?
@digitalizations 5 жыл бұрын
You are a genius :-) I would like to edit one of the socket to work on 14mm ball... But I don't know how to edit the files, you think I can put a spacer or some sort? :-)
@VivekSharma-xi9lh 5 жыл бұрын
Hey its very interesting ! Can I get editable files ?
@andreafernandez3859 6 жыл бұрын
Hi, I absolutely love this. Do you happen to have an editable format? I would love to test!
@bogas78 5 жыл бұрын
Hi nice project . currently i need to design few ball joints and here is my question what offset duid you used between ball and socket ? what gap should be in 3D file between ball and ball socket ( clearance ? ) thx
@Chunni24 5 жыл бұрын
does the joint hold in one place if you move it ?
@TommyTheMadDog 6 жыл бұрын
What material did you use to print that
@khoily9137 6 жыл бұрын
Hi, what is your thread dimensions? It seems to be a M20x1.5, am I right? Thank you.
@thered4048
Cool concept, thanks!
@rb4421 2 жыл бұрын
Brilliant just what I was looking for. Thank you uploader
@4funrc11 5 жыл бұрын
Hey, :) Thx.
@loszhor 7 жыл бұрын
Well done!
@CarlBugeja 6 жыл бұрын
Cool 🙂
@aaronramly1705 2 жыл бұрын
What layer height was this printed on ? does bigger layer height effect the grippiness ?
@assadlayne6446 3 жыл бұрын
How stiff is it tho? Would love to use this to articulate a toy but seems wobbly but hate what I have because the joints come out
@eternalblue_
very good
@jaydonmiller9511 2 жыл бұрын
Genius
@workstationguy Жыл бұрын
Hi. Is it possible to hire you to make, print, and mail a modified version of this?
Engineer3D
Рет қаралды 37 М.
3D Printing Professor
Рет қаралды 3,7 М.
Super Italiano
Рет қаралды 4,5 МЛН
Design Prototype Test
Рет қаралды 102 М.
Engineer3D
Рет қаралды 8 М.
Super Italiano
Рет қаралды 4,5 МЛН