Рет қаралды 209
Printed in PLA with 0,4 nozzle, 0,2mm layer height, 4 perimeters, 20% infill (grid) - which makes this print very sturdy (used almost 1/2 kg of filament)
I printed the 2 pins (that slide into the sides of the sliding jaw) laying flat on the sides.
I used the deburring tool on the 2 pins and the long flat slide piece because they were impossible to push in otherwise.
3D Model :
www.printables.com/model/2283...
(=Remix of original model by Josef Prusa)
Affiliate Links:
👉 Bambu Lab 3D Printers: shareasale.com/r.cfm?b=235472...
👉 Bambu Lab AMS: shareasale.com/r.cfm?b=235473...
👉 Bambu Lab Filaments: shareasale.com/r.cfm?b=235473...
👉 Bambu Lab Build Plates: shareasale.com/r.cfm?b=235473...
The links above are affiliate links: By using them I will receive a small commission per purchase at no extra cost to you! Thank you for using my affiliate links!