Great tip but you did excellent job that you have changed it to new ones 👍🏼👌
@user-li8gr8ur8l6 ай бұрын
Good tip mate
@b1h2u3p46 ай бұрын
Great tip
@raj0802883 ай бұрын
Do we have to remove the excess air before we remove and replace the shradar valve?
@johnoreilly44085 ай бұрын
I always use silicone grease. But usually once they're low on pressure, it isn't long before they're gone
@mickbmx6 ай бұрын
keep pressing it, it'll stop.
@adriancross46 ай бұрын
extension, always carry one in the service bag
@godthetrueking6 ай бұрын
Luckily I'm into downhill mountain biking. So I've got kit👍
@dannytwocakes91976 ай бұрын
PTFE and cap back on.
@matt88555 ай бұрын
Poke it with a small screw driver it will seal back up 😊
@NibblestheHamster6 ай бұрын
Or plug it with a little hose adaptor
@ep3thatsall4856 ай бұрын
Hose adapters ain't cheap. New valve pennies!?
@NibblestheHamster6 ай бұрын
@@ep3thatsall485 very cheap for a hose, but can’t always get to shrader easily, like a duo tech.. plugging it where it saves taking the vessel out completely, time is money
@Huseyinnn036 ай бұрын
Are you pumping Nitrogen gas or air?
@BrickTop9006 ай бұрын
Air
@Huseyinnn036 ай бұрын
@@BrickTop900 good job.
@mynameis97396 ай бұрын
Typical Vaillant.
@olliesutton18045 ай бұрын
Its a pressure vessel, they are the same on every boiler. At least you can actually get to it on a vaillant 😂