ARB Recovery Point Installation - Isuzu D-Max & MU-X

Рет қаралды 4,080

Күн бұрын

In this video we show you how to install an ARB Recovery Point on an Isuzu D-Max / MU-X Vehicle.
Why aftermarket recovery points for your 4x4 vehicle? Does your vehicle come equipped with factory 'recovery', 'tow' or 'tie-down' points? Are they suitable for recovery situations?
0:00 - Introduction
0:18 - ARB Recovery Point
0:35 - Preparation
3:21 - Installation
7:37 - Torquing
8:59 - Final Touches
10:27 - Conclusion
Some recovery situations can generate forces up to 2 to 3 times the vehicle's Gross Vehicle Mass (GVM). These forces are transmitted through the recovery gear (eg. bow shackles, snatch straps etc.) to the vehicle's recovery point(s) and then through to the vehicle's chassis. Whilst rated recovery gear is essential, what is the vehicle's chassis rated to? A properly engineered, tested and approved recovery point will allow the safe transmission of forces generated from the recovery through to the recovery point and ultimately the chassis. Therefore, a properly engineered recovery point considers not only the recovery point but also how it attaches to the chassis and ensures it won't damage the chassis at the full load rating of the recovery point.
Thank you for watching! Please subscribe: / @njsinstructional
Was this video helpful? Send a super 'Thanks❤️', it would be much appreciated!
#4wd #recovery #4x4

Пікірлер: 8

@browndogboy Жыл бұрын

Great instructional video. I bought a second hand 2012 D-Max fitted with an ARB bullbar, unfortunately when they mounted the bullbar the holes drilled through the chassis weren't close to perpendicular so when replacing the two smaller crush tubes & bolts, I had to die grind out the hole on one side of the chassis so the crush tube could fit between the chassis rail. Thanks again, you made it look so easy with good instructions.

@NJSInstructional Жыл бұрын

Cheers and enjoy your D-Max!

@willshunting Жыл бұрын

Excellent presentation. Do you happen to know if these recovery points are 'year of vehicle model' specific? This design seems like a radical departure from what I encountered when I last looked into RP's for my 2019 MUX

@NJSInstructional Жыл бұрын

Cheers. It depends, Recovery Points are unique to each make and model. However, the Recovery Points shown in the video should apply to all 2013 - 2021 (pre facelift) MU-X's and D-Max's.

@user-lo5mu5nn8g 10 ай бұрын

Hi I have just purchased the arb recovery point in your video, but my mux, which is the last model before the upgrade, does not have the 2 holes drilled into the chasis like yours for the top 2 bolts? Is my mux version different. I dont have a bullbar fitted. Thanks for any advice.

@NJSInstructional 10 ай бұрын

Cheers, thank you. Yes, the two holes you mention will need to be drilled. As this vehicle had an ARB Bullbar, these were already drilled for the fitment of the Bullbar.

@user-lo5mu5nn8g 10 ай бұрын

Any suggestions on how I might drill these holes at home

@user-lo5mu5nn8g 10 ай бұрын

Would I need to drill 2 holes, or will 1 be enough?