ASHS Larch Cladding guide

Рет қаралды 26,007

2 жыл бұрын

Scottish Larch Cladding Information and Instructional video for ASHS (Association of Scottish hardwood Sawmillers) from Scottish Wood yard.
A guide on what to expect from Scottish timber cladding and an overview of recommended wood types, installation practices, and techniques to ensure the best results in protective timber cladding.
www.ashs.co.uk
www.scottishwood.co.uk
www.scottishwood.co.uk/larch-...

Пікірлер: 16

@joshuasmith1215 2 жыл бұрын

Thanks for making this video. It's hard to find good and accurate information like this.

@markhaynes6410 2 жыл бұрын

Best video I've found so far for batten/board on board. Cheers.

@stevebullock9417 2 жыл бұрын

Best video I’ve found ! Thanks for putting together this content 👍🏻🌲🪚🪵👍🏻

@ryandavis6660 11 ай бұрын

Best introduction to cladding!

@alvinolson1 2 жыл бұрын

I just bought a Cedar clad house and your presentation was very helpful. Thank you

@Hoagie875 2 жыл бұрын

Very well done. Lots of great information.

@StuckInTheM1ddle 2 жыл бұрын

Really useful and well put together!

@siriosstar4789 Жыл бұрын

True about cupping and also true that sometimes if the board has a low moisture content it will crack down the middle of the width of the board when installing the screw .

@antonyporter5045 2 жыл бұрын

very good video

@ursamajor6546 Жыл бұрын

Fantastic! 👍

@davidrains3662 Жыл бұрын

Very informative video, I am about to start a new build timber house with vertical larch cladding, board on board, I have not been able to find much information on how to install the trim around the windows a video on this would be useful.

@joshuasmith1215 9 ай бұрын

Love the open joint but what about the UV rays hitting it through the joints?

@mattharrington1052 9 ай бұрын

How thick would your spacer battens be if you were installing vertical cladding onto a block wall with cavity house? How would you fix the battens to the wall? I.e. would only the spacer battens be fixed to the wall or would your horizontal support battens also be fixed through the spacer battens and into the block wall?

@mtbhighlands Жыл бұрын

If you have board on board do both bits want to be heart out? If the outside board is heart in then wouldn’t it cup with the board below or is it best to keep them all heart out?

@stevebullock9417 2 жыл бұрын

Best video I’ve found, thanks for the content 🌲🪵🪚👍🏻