Fiat 500 Easily Change Rear Brake Shoes, No Need to Remove Hub
Рет қаралды 9,513
Жыл бұрынFiat 500 Easily Change Rear Brake Shoes, No Need to Stupidly Remove Hub
I recently bought my daughter her first car. I’ve done oil and filter, air filter, cambelt, front brakes. For the rear brakes, seen one video where it was recommended to remove the hub for better access, there is no need to do that!
Take all safety precautions
This video is to be used as a guide
You must be competent mechanic and have the right tools
@mixmeister9985 2 ай бұрын
Great video 👍
@Law_Abiding_Citizen_ok 8 ай бұрын
Remove interior trim ( prob with oily hands!) instead of one 32mm nut🙄 Not a good idea to hold car up just on hydraulic Jack either😮
@MrBoehol 9 ай бұрын
It is not stupid to remove the hub . Then you can remove and replace the shoes and springs as a hole unit . No struggle at all with the springs .Uoe seems you have a small problems. The hub just take two minutes to remove.
@BarkyInnit 9 ай бұрын
And then you need to torque the hub nut to 200Nm. Each to their own, I’ve never had to remove a hub to change shoes, it is in my option stupid to do that. 😊
@thespian1961 9 ай бұрын
Good luck if the adjuster comes apart.
@johnlebihan6628 5 ай бұрын
lazy plain lazy .Remove the hub and clean the tone ring and inspect then re-grease and put back on.
@BarkyInnit 5 ай бұрын
Thanks for your comment. Never had to clean any tone rings before in 35 years of driving and maintaining cars. My philosophy is, if it isn’t broken don’t touch it 😂
@prawny12009 Ай бұрын
By pulling the shoes and adjuster apart with the hub on you run the risk of damaging the magnetic tone ring There is very little clearance between the adjuster, wheel cylinder and tone ring with the hub installed.
@mixmeister9985 10 ай бұрын
Great video 👍
QAZSPORT TV / ҚАЗСПОРТ TV
Рет қаралды 4,5 МЛН
МИЛАНА ТУТ 👀
Рет қаралды 7 МЛН
DER WERKSTATTHUND
Рет қаралды 13 М.
autodoc.de
Рет қаралды 66 М.