I got rid of the old coolant.Put new dexcool 50/50 with distilled water.Changed oil,and filter.Put new oil.Took the thermostat off.With engine cool,I poured in the Bars ..just like you said with heater on.No smoke..Engine runs cooler.Thank you so much.We need people like you,who try to help others.God bless you and your family.

thanks! I needed something to keep the truck going while saving up for the intake manifold gasket '87 F150 4.2L

Loved this honest appraisal from an obviously honest man from USA. If I wanted my good product appraised you need to speak to this individual

Thank you! I used it today 2.7.2024 for my 2004 Porsche Cayenne. I hope it works crossing fingers.

Thank you, I spent $500 in fixing my van and the shop blew my head gasket. I was about to junk it for $200. You saved me.

works for me! good to follow the directions............ let it cool after running awhile. Run w radiator cap off - purge any air in the system.

God bless you! Many thanks from Sweden! We all pray that the good forces in America will prevail 2024!

I used it on my crown Vic awesome job

Appreciate the video my dude. You definitely helped me out.

I had a very small leak on the plastic side of the radiator, where one metal tube connects to the automatic transmission. I patched it with regular acetic silicone (the transparent rubbery stuff) and after the first try it still leaked, however after the second re-patch I didn't notice any more leaks. Let's see how much that will hold. It's a 1991 Chevrolet Lumina APV 3.1L TBI (later called Silhouette and upgraded to 3.4L, 3.8L and 4 speed tranny). I replaced its defective PCM with a diy EFI (thanks Dielectric Videos channel for providing instructions). It's simpler than any commercial aftermarket EFI system; it only uses one Air Fuel Ratio map. I got to a point where the engine idles okay but when revving from 2000 to 2500 RPM, the exhaust sounds bad and the engine seems like it lacks power. After crossing the 2500RPM barrier, it sounds normal and regains power. Getting to this point, I had to modify the normal 2000RPM (all the way up) AFR of 13 or 12, to 6 (which is the limit of how rich the mixture can be). Letting it at 13 or 12 meant that the engine didn't even cross the 2500RPM - it was like a rev limiter, but the software only has a 4400RPM rev limiter. I asked the developer of the software about my issue and his guess was that enriching the post 2000RPM AFR compensated for another fuel problem (either blocked or small hoses, obstructed injectors, bad fuel regulator, clogged filter or bad fuel pump). I inspected the fuel pump and the pressure regulator for cracks, didn't find any; replaced the fuel filter... I don't have a pressure meter though.

Bought same bottle and poured in 2003 solhoutte White smoke gone...so far so good

Thanks for the info!! Great video!!!

Thanks I used K seal it worked for 1 month but it slowed it down but now I'm loosing more coolant the good thing is that my oil is not creamy I'm loosing the coolant somewhere else in the block.. my next additive will be the product you used to be honest I was going to use it first but Kseal was cheaper on sale so I went with that.. long story short Kseal did not work long term for me.

My 12 valve cummims was weeping a little bit through a corner, used bars stuff and stoped the leak, its my daily and makes 550hp to the wheels, i figure as long as you dont have cross contamination, this stuff really is miraculous

Great vid. I heard the talk show guru talk about steel seal in the past with no failures. At that time it was $80 or $90 dollars. Thanks for putting up this video for a product that is much more reasonable to buy. You mention chevy 350 throttle body. Where to start with zero idle without constant throttle input? Thanks in advance.

Put the exact same thing in my Subaru. Due to its small cooling system, I was suppose to only put in half a bottle. 6k miles and working fine.

Thank u! I love your truth bro!

Is it still holding up? How many miles has it run since you put it in the coolant?

Hi. I have a 2008 Rav4 with the 3.5L v6 engine. I have no symptoms at all, but I saw a little pink , (calcium like) dried patch. I don't know if my vehicle leaked at acertain time and stopped, or it a very minor outer leak. But I will try this and it should prevent and stop it in the tracks.

Great video thanks , hope you get better

I just used this on a 2006 equinox and it seems to be working It’s pretty cool for a 3500 dollar car

Thank you so much. I sure appreciate u!!!

So after the fix should you drain the coolant and replace with regular coolant to get some of that sealer out so it wont clog anything?

I used the block seal they have and it worked amazing!

My coworker had a civic that kept pushing all the coolant into the reservoir but never pulled it back into the radiator so that lose of coolant would cause the car to overheat. Turned out he had a small head gasket leak he used this product and 6 months later it's still working good with no issue.

Thank you brother!!

My minivan over heated on interstate and the coolant was pouring out of a crack in the tail pipe...I checked the oil oil looks fine. Thermostat works good..no misses...no leak around the engine...just the bad leak around the catalytic converter..I'm thinking it's a intake leak...I loose about a gallon or more of coolant after it get to warm temperatures..I tried blue devil but I think the leak is too big for it...I hope this works..I'm getting some today....

great video thanks

Definitely seen enough good recommendations. I guess I'll gamble the $$$ and cross my fingers.

I have a 2006 Ford Freestyle. I don't know anything bout fixing a car & I have never owned a Ford ...it was actually given to me. So huge blessing. I knew it been sitting for long time. The man said it needed the water pump replaced. But anyway I drove it down the Rd. Went dead few times. Figured it might need an alternator. But the durn thang , got home it was smoking like a freight train. Checked the oil mine looks like a butterscotch milkshake...I went last night and bought this stuff y'all are talking bout. So I do need to change the oil first?? Can anyone tell me if I should replace that water pump first. I'ma single mom and I don't really have the money to take it and have all this done. I'd appreciate any suggestions any of u might have. Thank ye for the video

Do the car have to be running when you pour the stuff in

Omg it’s working so far this is a miracle

Did you remove any of the spark plugs or disconnect any injectors on any of the cylinders that were burning coolant? Bar's says you don't need to do this, but Steel Seal (and Scotty Kilmer) recommend doing this.

How about if all engine oil goes in to the radiator? This stuff can help?

That bad boy work foreal no lye boss

How do I determine if my coolant is dirty and needs flushed first or not ? Thank you!

My 2001 Aztek overheats. I used this product 6 months ago. Now it's overheating again within 10 minutes of driving. The coolant blows out my overflow. When I originally put the bars leek in I put it in my overflow. It plugged up my overflow tube. And half of it never got in my engine. Then it eventually blew out my overflow. This time I'm putting directly in my radiator. I think it will work and hold longer until I can afford a garage fix. What say you?

1997 f150 4.6 got gunk in oil doesn’t overheat white smoke running rough should I try this not worth head gasket change

My 89 Sierra blows smoke out when I rev the engine what could be the problem would this help

Hi i have a bmw n55 3.0 liter i went to the dealer they just cant find anything i have to put 1 time a week like 1 bottle of water will it help for my car please ?

I tried "Bar's Leaks Block Seal Head Gasket Fix". I didn't work for my Maxima 2012.

I like his southern boy character :)

Is it still holding up? Thinking about adding this to my truck.

I have a small coolant leak otherwise my car runs fine. Occasionally it miss while accelerating. Bubbles in rad. Other then that no visible leak. Should I try this ?

Do you think it will plug the heater core?

sometimes good to set this up with the thermostat removed - Ive heard.

Got that ol ,synthetic ol that is

Is it safe to pour a second bottle in radiator ? It fixed my car for about a day but the car started overheating again. I’m thinking one more bottle will do the job

It worked for me took about two days for it to stop smoking.

I'll let u know if it works for me

Is the stuff worth using 2015 ford fusion?

Still working after 4 years?

What is a MOSSGITA truck ,forgive my ignorance?.

Does it actually work

I just tried it I will let the people later coming soon

Guess it still works lol

Didn't fix mine. !!!! Wasted $30. Over heated and went. All over the ground... 1/2 hrs. After putting it in ....

MAGA