Basic Wiring on a Simplex 4010 Fire Alarm Control Panel

No video

Basic Wiring on a Simplex 4010 Fire Alarm Control Panel

Рет қаралды 4,650

Fire Alarms and Such

Күн бұрын

Пікірлер: 17

@macarthurwalker6378 4 жыл бұрын

Thank you so much for this video! It was just what I needed. I just purchased an annunciator for my 4010 and wanted to know how to wire it. Your video was so thorough. I came with one question, but you answered that one and so many more. Thank you Thank you Thank you.

@socratesm6470 5 жыл бұрын

Very nice awaiting for more videos

@SouthwestFireAlarms 5 жыл бұрын

Very Helpful!, this may be my next panel!

@tinotendachiz8067 Жыл бұрын

Thank you soo much bro. Can you please connect a flame detector and test it . Please

@evanbart4109 5 жыл бұрын

Great video 😀👍👍

@nm4fsv684 5 жыл бұрын

Cool!

@camaronruss9476 3 жыл бұрын

Hi I found just the screen and buttons but no actual panel is this what it is?

@Wmofnmproductions 5 жыл бұрын

Awesome video! Will you be testing the fa system at your dads work again?

@FireAlarmsandSuch 5 жыл бұрын

I hope too!

@alarmtech5909 5 жыл бұрын

so when you t-tap, do you connect them using the clips shown on the transformer?

@FireAlert 5 жыл бұрын

cool

@THRIQUILLED 5 жыл бұрын

Hey Man! Awesome info on these vids. Can you go through the wire planning process on the prints? Every time i draw my plans out on how im gonna run my fire alarm wires. (16, 18 gage NAC, and SLC ) theres always something that my lead tells me im planning wrong. Hes explaining why its wrong but im not seeing it. I think hes just lazy.

@FireAlarmsandSuch 5 жыл бұрын

Can you elaborate more?

@THRIQUILLED 5 жыл бұрын

@@FireAlarmsandSuch yea So when you get the prints to a new project, a brand new comercial building or an existing building with existing multiple devices, I'm told my planning and executing of the wire pulling part of the job is either wrong or the long way. I guess I want to see how you would begin planning and mapping a wire pull on your prints. If that makes sense.

@FireAlarmsandSuch 5 жыл бұрын

I didn't do mine class A. Instead, I used the supervision of an addressable module for supervision. What I did is I ran one channel out from the panel (in the sense of an SLC) and t-tapped off the channel, branching to each device.