Hi, I just bought two of these boards for two CR-10 S5's I have. With such a big bed, it seemed wise to have independent control of each Z motor. I've installed many SKR 1.4 Turbos and SKR E3 v3 Minis. Question - do you have to snip off a pin if you aren't using sensorless homing? I had to do that on the 1.4 Turbo since I am using the 3D printer's limit switches. Thanks!

I just checked your link for the SKR 3 and for the price you are getting a lot. I'm curious as to why you're using this on an Ender printer? I started with a CR10 printer and it's running a CR10S motherboard as I wanted dual extruders but haven't seen the need for a higher horsepower MB. It has been the most reliable printer I've owned. My only wish for it would be better material choices (ABS, Nylon, etc) but for PLA it's a workhorse for me. Anyway, I'm looking into building a core XY printer and probably will go with this MB for it. Hope all is well with you and I want to say I've enjoyed all of your videos. Please keep them coming. Thanks!

де знайти інфу стосовно того які джампери мають бути встановлені для різних драйверів