BMW N54 Front Crank Seal

No video

BMW N54 Front Crank Seal

Рет қаралды 10,129

AUDImotive

Күн бұрын

Front crank seal replacement on a 2007 BMW 335XI. I am using the recommended factory service tools

Пікірлер: 22

@SonoDoc76 2 жыл бұрын

Thanks for this great tutorial! I'm about to tackle my front seal gasket right now and this put all the steps in perfect perspective!

@husamkazak2034 6 ай бұрын

Thanks

@awaspthatswatchingyou4559 3 жыл бұрын

Mad respect, good tutorial. Love what you you said the end. If you in fairbanks let me know if you need to use the tool. I wish I was in fairbanks because I need to do mines😂

@kennethlanier3604 Жыл бұрын

EXTRA TIP: You ONLY need the first tool to remove the seal. Once you screw it down you use the supplied dry wall screws and screw them into the seal through the holes on that first tool. Then you unbolt the tool and use a wrench to twist the tool’s pin and it backs out the seal towards you.

@tonyo5697 2 жыл бұрын

Great video

@UlisesACA 3 жыл бұрын

Thanks for the tutorial man I just replaced my valve cover and oilpan gasket it’s still leaking I’m thinking it’s the front main seal hopefully that’s it

@audimotive 3 жыл бұрын

Have you checked the oil filter housing gasket?

@UlisesACA 3 жыл бұрын

@@audimotive yeah ive seen it no oil puddles up there and my belt is dry so it should be one of the seals it goes through 5 quarts every 2 days 😅

@audimotive 3 жыл бұрын

Yeah that's no good. Hopefully not the rear main

@Bussdownbandit Жыл бұрын

@@UlisesACA u sure you wasent burning oil? Lmao

@freddymenjivar9809 Жыл бұрын

Thank u my guy 😊

@ChumblesProductions 2 жыл бұрын

ANy advice on setting up a pro starter kit for the audi 2003 1.8L?

@boost7236 4 ай бұрын

Hey man I have a question do you have to use that specific sealant?

@audimotive 4 ай бұрын

It comes with the kit. Not sure how you would inject your own sealant in those split locations

@csaylo 2 жыл бұрын

how long as for the curing time for the primer and sealant

@cefforo2005 3 жыл бұрын

Is it the same tool for N55 ?

@audimotive 3 жыл бұрын

Same tool

@anthonyjordan7847 2 жыл бұрын

Cant u just replace the crankshaft pulley Do u really need to replace seal as well

@kennethlanier3604 Жыл бұрын

You want to replace this seal if your belt snapped and wrapped around the crank pulley and then even contaminates the seal or gets sucked through into the engine. Once I pulled the seal I found BELT BEHIND THE SEAL! So my engine would have been wrecked if I just changed the pulley. Now I also have to drop the oil pan gasket to check for belt debris

@audimotive Жыл бұрын

The seal isn't too expensive or hard to replace. Cheaper and easier than doing the job again just for the seal