Looks great, I'll be doing this to my VStar.

Best looking and sounding video yet! Keep it up!

These new LED turn signals have a frequency of about 120 times per minute. This is not allowed in Germany and the EU. They are only allowed to flash about 60-90 times a minute. For this, resistors or a new relay must be installed, because the original relay wants to see at least 21 watts. But the new turn signals only have about 1-2 watts. In your case, it could even have been that your new turn signals would have only shown steady light. … But anyway, you made a good job. … Best regards from Germany.

I see you Bernie Hope all is well Btw the bike looks great 🤙🏼💪🏼

Thank you. Didn't upgrade, just needed to see what I needed to do to replace the frame of the lighta.

I wont to Bob my v star 650. Problem is im in love with the way it looks now. Can I keep my original seat and buy an after market rear guard? Im going to place the break light under the rear guard. and add led indicators just b4 the end of the rear tyre facing the rider . Im also going to strip the front guard and leave it raw.... or get a small replacement

Maybe the mounts would have looked better the other way around, do the cables would be hidden behind the forks... Looks good nonetheless!

superb bike, I love your handlebars, did you need to modify the cables? Is it good with the original cables?

Your turn signals only had two wires. What did you do with the black wire. Because of the two wires I now have nothing connected to the black wire in the headlight housing. When i just hook the blue and green or blue and brown i get a hazard lights effect. Because theres no 3rd wire.

Do you have a vid of how to relocate the rear lights on a v star 650?

What kind of mounting hardware did you use and or can be used for this? A windshield bracket? Where do I get that

WHAT DID YOU DO WITH THE STOCK SIGNAL LIGHTS YOU TOOK OFF YOUR BIKE, ID LIKE TO BUY THEM IF I COULD, THANKS

If the original going to the headlight is 3 wires and the new blinkers are 2 wires I guess I am lost as to how they connect

Looks great. Parts supplier? Part/kit p/n?

So what size front forks do you have and would you be interested in selling the old signal/mounts you took off? 😊

Where did you buy the mounting fork clamps ?

What about the rear. Does nobody change those?

Mine only does hazard lights what does that mean

Probably JIS not Philips. That's why so many screw heads are messed up.

Not a huge fan of the turn signals… they look a little bit sporty for my taste in cruisers. But to each their own. Love the handlebar option, and your headlight looks more streamlined than mine. I plan to cut the stock light bar down short to tighten up the front end. I would highly suggest checking out the website 650ccnd.com They have the best library of DIY mods for your bike and a great forum to match. Ride safe out there!