Chevy Equinox P0172 How To Replace High Pressure Fuel Pump

No video

Chevy Equinox P0172 How To Replace High Pressure Fuel Pump

Рет қаралды 18,356

Күн бұрын

If you guys have code P0172 or are having drivability issues or even spelling has outside or inside your oil, you might have a faulty high pressure fuel pump. In this video we show you guys how to easily replace the pump along with the fuel pressure line. This is for Chevy Equinox with the 2.4 ecotec engine. Hope this helps and good luck!

Пікірлер: 35

@richboutabag8556 Ай бұрын

Will replacing this part fix my low power mode problem? Goes it to low power mode mechanic said code was fuel injected pump

@acetechauto7 Ай бұрын

Yes this will fix that issue as well if the code is related to the fuel pump.

@jessicabillman1256 4 ай бұрын

Im about to do this same job. Do you have any reccomendations on how to remove the fuel line without the tool for the prongs?

@acetechauto7 4 ай бұрын

It’s going to be pretty difficult without the tool I would just go buy the tool at any autozone or Orielly’s. It’s not that expensive and it’ll save you the headache. Good luck!

@sarahdugan8686 2 ай бұрын

What's the prong tool called? Or is that what it's called? Lol 🤦🏼‍♀️

@acetechauto7 2 ай бұрын

That’s called a fuel line disconnect tool

@Sandbagsims 4 ай бұрын

Thanks for the video. Did you have to bleed the fuel line first before removing it?

@acetechauto7 4 ай бұрын

You don’t have to. Just slowly unscrew the fuel line and wait for all the fuel to leak out and that’ll release all the pressure in there. Good luck!

@joe9824 12 күн бұрын

I saw another video on this and they did a camshaft adjustment. Is that not a necessary thing? Mine is a 2011 model.

@acetechauto7 12 күн бұрын

No you won’t have to do an adjustment after this

@joe9824 12 күн бұрын

@@acetechauto7 thank you so much. I was dreading having to try it.

@acetechauto7 12 күн бұрын

No problem good luck with the repair!

@thequintessentialgamer7514 5 ай бұрын

Do you need to replace the cam follower when you're leaking gas into your oil? Mine is getting the "P0172 - system too rich bank 1" and is dieseling when you shut it off. I ordered a new pump and new line but no cam follower. I also ordered a "High-Pressure Fuel Pump Installer EN-48896" because a different video said i needed one to line up the camshaft before installing the new pump, but you didn't use one at all. So did I just waste $55 on some bogus tool that resembles a butt plug?

@acetechauto7 5 ай бұрын

lol that’s the way to do it if you’re doing it by the book. You’re suppose to put the butt plug in there and rotate the crankshaft clockwise until it sits flush. Otherwise you can stick your finger in there on the cam follower and rotate the crankshaft until it goes all the way down and stop rotating when you feel it starting to come back up. As far as the cam follower if you’re able to locate one easily I would replace it while you’re there otherwise if not no big deal.

@thequintessentialgamer7514 5 ай бұрын

@@acetechauto7 so you can either shove a butt plug into it or you can finger it.. noted.. thanks for your response mate!

@acetechauto7 5 ай бұрын

@thequintessentialgamer7514 no problem! Either one or the other will work to turn them on.

@MikeDGreat30 19 күн бұрын

Does this issue cause oil to go low?

@acetechauto7 19 күн бұрын

No this won’t cause it but these engines are known to burn a lot of oil

@jasonsantiago2374 Ай бұрын

Ive replaced this, both fuel pressure sensors, cleaned injectors, replaced MAF, CAT and the damn car still wants to shut off when its in drive. If i put it in Neutral, the car runs fine. IDK what else to do.

@acetechauto7 Ай бұрын

Sorry to hear about your troubles. Is it setting any check engine lights on?

@adriangarcia2599 Ай бұрын

Timing chain could be messed up

@colleenkokko1347 15 күн бұрын

Transmission sensor maybe?

@DaBurnerr 6 ай бұрын

Why didn’t you replace the cam follower while you were at it

@acetechauto7 6 ай бұрын

You can if you'd like but it wasn't necessary in this case

@shairanieves1487 2 ай бұрын

I have a Chevy equinox 2016 it came p0172 and p0191 code every time I turn off the car it still runs a little bit what can it be ?

@acetechauto7 2 ай бұрын

It can be your fuel pump

@Father_Adrian 19 күн бұрын

Any idea if the p0172 would cause the p0420 code for bank 1?

@acetechauto7 19 күн бұрын

No this won’t cause the p0420 that’s separate and you’ll need a catalytic converter for that and alot of times the exhaust manifold cracks on them too which you will find out once you take the heat shield off it when doing the catalytic converter

@Father_Adrian 19 күн бұрын

@acetechauto7 so I just replaced exhaust manifold bc of a crack after redoing timing...car is running fine, but then got p0172 and p0420 at the same time...I should replace the high pressure pump right to correct p0172, right? P0420 still a separate issue?

@acetechauto7 19 күн бұрын

@Father_Adrian try clearing the codes first and see if they come back. If they do then most likely you’ll need the high pressure fuel pump and a catalytic converter.

@Father_Adrian 19 күн бұрын

@acetechauto7 gotcha! Appreciate the advice! 1 more thing, I saw someone mention the butt plug tool thing lol, I don't have that, so am I able to install just as you did and have everything line up properly? I dont want to mess up anything Internal

@acetechauto7 19 күн бұрын

@Father_Adrian lol nope you won’t need that. Just follow the steps in the video and you’ll be fine.