Ive watched at least 30 videos of this job and no one has taken a pic of the linkage. Thank you for that !

I know this is an older video but I just fixed a 12.5 Briggs with a Nikki by changing out the fuel inlet o-ring and gasket (diaphragm gasket?) and giving it a good clean. While mine wasn't pouring gas into the engine it was pouring it out of the carb since the tiny o-ring from the fuel inlet was just toast, and for less than $10 it was an easy fix. Granted my LT3800 Huskee (with easily 1200+ hours on it) has had 0 engine work (other than oil changes) since 2009 I would say the mower has held up really well, granted also the Nikki carb I have on mine doesn't have the electric solenoid it is otherwise the same carb. I did also add a fuel shutoff and bigger fuel filter just to make it last longer, and since it lasted 15 years with the stock fuel stuff I'm hopeful that I can get another 15+ years out of this new setup.... and for less than $20 that is money well spent to me. ☺

Great video , can’t wait to see the spikes on it . Have a good one buddy . Del

Thanks for your video you was very helpful.

I always install a gas shut off valve on my mowers and equipment, turn off the gas flow and run the engine till it quits, saves me future problems.

Taking a picture is always a good idea. Saves alot of half ass guessing later..

I have 2 or 3 that have dumped all the gas into the engine. I need to order a couple of carbs too. I also invest in cut off valves because I never know when they are going to dump the gas again. Thanks for sharing.

Funny that you forgot to put in the spark plug because I’ve done stuff like that. Thank for the video

Great video, thank you!

Hamesha khush raho my friend 👌

Great video. I have that carb on a19.5 that I'm putting on a Dixon 0-turn that does not have the solenoid and plunger on the float bowl. How do I wire this plunger into the system when there is no plug already there. How do I wire this in.

Thanks ❤

Have you had to replace the deck belt on this mower? I just got an lt1000, with the 18HP Briggs. It came with a 94” snapped belt, I’m reading 95,951/2, and 102 online. Let me know, thanks!

Is there any way to put every engineer at Nikki in prison?

Did you change the oil.

where did you get this carb? 20 dollars seems very cheap I cant find one for that price

You had a sorry NIkki carb and you bought a Nikki after market carb. You will begin to have trouble with this one too...soon. Nikki is the worst garbage of a carb that you can own. Just buy a Briggs and Stratton Walbro carb and replace that junk with the Walbro. Part number 594593.