does crc qd electronic cleaner FIX sticking power window switches (SOMETIMES)

No video

does crc qd electronic cleaner FIX sticking power window switches (SOMETIMES)

Рет қаралды 42,684

Күн бұрын

Before you pull the whole door panel off , There’s a few things you can try. You can buy non-conductive contact cleaner. There are times I’ve sprayed this in and the switch starts working just fine. Other times the switch is too far gone you can feel everything move, the switch itself is totally worn out. When this happens about the only way you can fix it is a new switch. Often times you may be surprised at that the switch it’s not as expensive as you may have thought but there is the process of pulling the door apart and replacing the broken part
Power window switch fix
Automatic power window switch
How to repair a window switch for a power window
How much does it cost to fix A car window switch
What causes a car window to stop working
What do you do if a car window won’t go up
How to fix power windows
What to do when your car window won’t budge
Power window switch repair
How to fix a stuck car window
How do I fix a broken car window
Power window switch repair cost
How to check power window switch
Power window won’t go up quick fix
How to tell if your window switch is bad
Power window switch fix

Пікірлер: 32

@robertlee4172 4 жыл бұрын

IT'S CALLED 'CONTACT SPRAY' FOR A REASON.....you spray it on contacts. Not door panels.

@iLuvTheMostHigh 4 жыл бұрын

Robert Lee How do you access the contacts on the car door window switches?

@robertlee4172 4 жыл бұрын

@@iLuvTheMostHigh You remove the door panel with clip tool and proper screw drivers. Some finess required too.

@Beachbum71 3 жыл бұрын

Yet it works. It worked on my seat switches. Just did it yesterday.

@mickbailey4702 3 жыл бұрын

The switches should have been removed and the connectors disconnected to ensure a more thorough cleaning and eliminate the chance of shorting out the circuit board. If the ignition switch time delay relay was still supplying post-switch-off power to the switches the spray would short out the board. Spraying the surrounding trim plastic and fabric could have marred and or bleached it.

@MarzNet256 3 жыл бұрын

You could also try using compressed air to blow the cleaner further into the switch mechanism and possibly blow out some crud.

@Kingriker4 2 жыл бұрын

This spray did the trick do this before buying new switch!!

@danielmalloy6093 Жыл бұрын

After fuses and relay, the only thing left was the master switch. Electrical cleaner on terminals and lots of dust on buttons. Works perfect.

@faheemkhan359 Жыл бұрын

Where is master switch located???

@thzrealist 4 жыл бұрын

You got a new switch, anyway you gonna dismount the old one out and replace with the new one. But why are you spraying through the plastic instead of dismounting old one and spray it with contact cleaner properly for the best result. omg as and IT technician it was hard to stand it. Sorry for my reaction but it is.

@nathanhamman418 4 жыл бұрын

It is hard to watch, spraying the plastic and hoping it hits the contacts isnt really a great plan

@LoudLipLooseLips 2 жыл бұрын

@@nathanhamman418 it's an easy plan. it works most of the time. when it doesn't THEN I'll go to the more time consuming plan and pull the panel off.

@kennyhendrix2028 4 жыл бұрын

Great video live free. It pouring outside and my window won’t go up. I’m going to spray that contact spray under those buttons, cross my fingers and say a prayer that I hit the correct contact before it evaporates. Guess I should get two cans for my two hands. Double blast it. Under the right conditions it will work when you’re in a spot. If it doesn’t work I may take it to an IT guy, or a blacksmith, or a hot air balloonist. It’s amazing how much time people put into bashing other people. Some comments are just not necessary. You did good

@gamervet7793 4 жыл бұрын

10 dollar switch. good for you. my soul switch is 120 dollars lol

@tahotoy 3 жыл бұрын

The contacts are under a membrane. Open the module and only wipe the pcb side.

@corkyvanderhaven3391 2 жыл бұрын

Silicone the window slots, to ease power to the window and resistance

@guidoloiacono2629 3 жыл бұрын

if you disarm the windows keys you will realize that your job is completely usless

@galactic904 2 жыл бұрын

Rain Water got in the power windows button and now it feels sticky. Perhaps WD 40 silicone ?

@mikeblaz 2 жыл бұрын

Had a problem like this but I didn't half-ass it. I removed the switch, took it apart and cleaned the shit out of the contacts. Reinstalled and everything worked properly and responsive. You wasted time and money from buying one off ebay...

@thecartinkerer 5 ай бұрын

My God, you need to dismantle it first hahaha, but i dont knw if you did that on purpose....wth hahahaha cheers from Manila

@Initial_Gain 3 жыл бұрын

Spraying that way is not good... you should only spray the contacts. The cause could also have been dry joints. After spraying the contacts you should workout them several times with no supply present, that is with the ignition off. At 10 dollars I would have just replaced them anyway as they're quite cheap. I don't know what CRC exactly is but it has to be a contact cleaner not just stated as electronic cleaner. If it evaporates quickly it's no good. You should use contact cleaner... I usually use Kontakt-60.

@jettrink7510 3 жыл бұрын

@Dan_druft 4 жыл бұрын

Use WD-40 instead it works a treat

@Initial_Gain 3 жыл бұрын

WD40 is not a contact cleaner. It's ok if you use it afterwards... when you've got the contacts going...

@Dan_druft 3 жыл бұрын

@@Initial_Gain no just squirt some on all the buttons and it will eventually work no problems . I've done it on 4 different cars and it works every time

@luisvelasco316 2 жыл бұрын

WD-40 makes a Specialist Electronics Cleaner. Highly rated on Amazon.

@Dan_druft 2 жыл бұрын

@@luisvelasco316 Yes I bet that works a treat to, but you don't have to go out of your way to buy some just to fix window buttons as WD-40 works really well.

@luisvelasco316 2 жыл бұрын

@@Dan_druft Unfortunately, that kind of thinking deprives the company of another revenue stream!