GREAT video. I just took over QC at my company and we had so many mics out of service because of barrels were off and I guess no one took the time to figure out how to fix them. This was HUGE help thanks!!

Thank you for this detailed video. The tip to tighten the micrometer in a bench-vice was exactly what I needed to adjust my tool perfectly.

I just inherited a vintage Browne and Sharpe that needs minor adjustments. Your video helped me do so

Thank you so much! Just bought a used micrometer and its thimble was off by 15 thousandths from the digital reading. It's a digital Mitutoyo and it works the same way on the thimble assembly. I really appreciate the help.

Thank you very much for showing how to repair / reset a micrometer. I dropped mine and couldn't get the calibrations back in the original position. I didn't know the procedure on pulling the barrel out procedure. Can't wait to get in my workshop in the morning and cure the problem

Thanks! I just bought a micrometer and I did not understand that small part of the key, the one you used first, to make the first adjustment. Now I understand it all. Thanks again!

Thanks for sharing this video. I am taking some machining classes right now. Watching this video filled in some gaps I didn't understand when reading how to calibrate a mic.

Thanks for the great video. I was able to calibrate my cheap Alltrade micrometer using the technique you showed here.

great video

Had an issue with a customer mic. The zero was position 90 degrees down when i checked it. But when i saw how you popped the barrel off, I did the same to the mic I was working on and it reads perfect across the range. Just when you think you know something, you learn something new.

Great video. Thank you.

Very good video regarding zero adjustment i like this technic. THANKS

Thanks a lot for upload this video, dear friend. I need this for calibrate a micrometer Mitutoyo. Greetigns from Chile.

Thanks for the help! Needed to measure my cylinder and piston on a quadzilla 500 they were out beforehand.

W⭕W this was very helpful and helped me celebrate my fussy Xmas present mic...it was 3 microns out on the vernier with a very stiff sleeve. The thimble removed easy and I managed a good zero-line-reset. I collect quality mics, have about 15 of em, all B💥NG on accurate to the micron or 10thou.

Great video

Great video thanks!

I have one with the pointed spindle. One end is broken, how do I take it out and replace it?

Thanks

Very good & usefull vedio

Great job thank you

Great to know,thank you….Bob

Amazing camera work bud, totally didn't give me a stroke.

Thank you.

thx

Thank you very helpfull

Благодаря!

Help me setup a mic and get the thimble back to zero setting. Thanks

thanks i fix my is working good

first step after using test peice is to doble check all faces clean . the check again . I seldom have had to adjust a micrometer despite the fact they are used often and often not treated well

Our mic 0.25 positive err, Thankyou so much sir

Tq useful msg

How to remove and correct 0.1 to 0.3 error in micrometer??? please tell me...

Is this also valid for Brown and Sharpe?

Thanks